Gallo TR-3D Kullanıcı El Kitabı - Sayfa 9

Subwoofer Gallo TR-3D için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Gallo TR-3D 16 sayfaları.

Sayfayı Yazdır

CONTROLS

CROSSOVER

The CROSSOVER control is variable from 50Hz to 180Hz. In

simple terms, the subwoofer will play all frequencies below

the CROSSOVER setting.

LEVEL

The LEVEL control sets the volume of the subwoofer in

relation to the main speakers. Once set, volume will climb and

decrease along with your main system volume.

PHASE

The PHASE control allows you to adjust the phase of the

subwoofer relative to the main speakers. This helps when

positioning the subwoofer - in general, if the subwoofer is

in front of the listening position have the PHASE set to 0º. If

the subwoofer is behind the listening position, then set the

PHASE to 180º.

BYPASS/CROSSOVER

Activates the subwoofers built-in bass management, or

bypasses it. If your amplifier has bass control, like an AV

receiver, then set to BYPASS, otherwise set to CROSSOVER.

BASS BOOST

Allows for more convenient bass equalisation, increases bass

volume in relation to the main speakers without adjusting any

other controls.

POWER SWITCH

Set to either OFF, or AUTO ON. When set to AUTO ON, the

TR-3D will automatically detect a signal from the source

amplifier and, in turn, will power up the subwoofer. It will

also return to its standby mode automatically when the source

is no longer detected.

AC SELECTOR

This should be preset to your country of use. However you

can adjust this if you move to a country where a different AC

voltage is used. Note that you will also have to change the

internal fuse to suit the AC voltage.

CONNECTIONS

HIGH LEVEL IN/OUT

The HIGH LEVEL IN is used to connect your amplifier

to your subwoofer using speaker cables. You can then

connect a pair of speaker to the HIGH LEVEL OUT. This

will also activate the subwoofers built-in crossover, and

protect the speakers from the lowest frequencies.

LINE IN/OUT

This is used to connect your TR-3D to your amplifier

using a coaxial (RCA) cable. Connect the pre-out or LFE

(SUBWOOFER) output on your amplifier to the LINE IN

on the subwoofer. If required, you can connect the LINE

OUT to your power amplifier.

POWER CONNECTOR

Plug the AC power cable here, and then into a mains

supply, do this after all other connections have been

made. Ensure that the AC SELECTOR is preset to the

correct position for your country.

FUSE

The fuse protects the TR-3D subwoofer from abnormal

power conditions. It's located under a small cover in the

subwoofer AC power socket. If the subwoofer fails to

power, check this fuse and only replace with the types

noted below :

115V AC Supply - T5A 250V fuse

230V AC Supply - T2.5A 250V fuse