Gallo Tech GStarter I Kullanım ve Kurulum Kılavuzu - Sayfa 5

Uzaktan Çalıştırıcı Gallo Tech GStarter I için çevrimiçi göz atın veya pdf Kullanım ve Kurulum Kılavuzu indirin. Gallo Tech GStarter I 12 sayfaları. Push button start & alarm system with 2 remote key fobs

Sayfayı Yazdır

Lock/Unlock siren Chirp: If this option is set to DISABLE the siren will not chirp when locking and unlocking the

doors.

Two Pulse Locking / unlocking:

locking/unlocking mechanism can be set at either one pulse or two pulses. Most vehicles only require one pulse

(factory default). Some vehicles require one pulse to unlock the driver's door only and a second pulse to unlock all

doors. If this is the case and you want all doors to be unlocked at the same time, set this option to two pulses. OR,

setting to one pulse will unlock the driver's door on the first unlock button push then unlock all doors on the second

push.

Ignition Key Start Function: If this option is set to ENABLE (factory default) the vehicle can be started by

using either the ignition key or the ENGINE START push button. If this option is set to DISABLE the vehicle can be

started with the ENGINE START push button only.

Disable Start Button Cut Off Delay: If this option is set to ENABLE (factory default) the vehicle can be started

after the ignition key is turned ON and there will be no start button cut off delay.

30 Second Start Button Cut Off Delay: If this option is set to ENABLE the vehicle can not be started 30

seconds after the ignition key is turned ON. Recycling the ignition key OFF to ON will reset the time delay for

another 30 seconds.

60 Second Start Button Cut Off Delay: If this option is set to ENABLE the vehicle can not be started 60

seconds after the ignition key is turned ON. Recycling the ignition key OFF to ON will reset the time delay for

another 60 seconds.

5 Minutes Start Button Cut Off Delay: If this option is set to ENABLE the vehicle can not be started 5 minutes

after the ignition key is turned ON. Recycling the ignition key OFF to ON will reset the time delay for another 5

minutes.

10 Minutes Start Button Cut off Delay: If this option is set to ENABLE the vehicle can not be started 10

minutes after the ignition key is turned ON. Recycling the ignition key OFF to ON will reset the time delay for

another 10 minutes.

1.4 PROGRAMMING FUNCTION SET UP OPTIONS

This section explains how to configure the

of each function.

1. The system must be in DISARM mode, and the Ignition key must be in the OFF position for a minimum

of 3 sec.

2. Cycle the Ignition key OFF/ON 3 times, and keep the ignition key in the ON position the 3rd time. After 3

sec the parking lights will flash 2 times indicating the function setup mode has been activated.

3. Press the ENGINE START button OFF/ON "n" times and on the nth time hold the ENGINE START

button in the ON position for 3 sec. The parking lights will flash either 3 times or 1 time indicating the

state that the function option has been changed to.

4. After turning the ignition key to the OFF position, the parking lights will flash 5 times, indicating the

Function Set up Mode has been exited.

5. To change another function option repeat steps 1 thru 4 above.

NOTE: "n" indicates the number of times the ENGINE START button is to be pushed for the respective Function

Option in the first column of TABLE 1 below.

Gallo

When pressing

functions. See section 1.3 for detailed explanation

- 5 -

the electrical pulse sent to the door

52008