Galls Street Thunder ST280 Kurulum ve Kullanım Talimatları Kılavuzu - Sayfa 5
Amplifikatör Galls Street Thunder ST280 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Talimatları Kılavuzu indirin. Galls Street Thunder ST280 20 sayfaları. Siren amplifier & light controller
Ayrıca Galls Street Thunder ST280 için: Kurulum ve Kullanım Talimatları Kılavuzu (18 sayfalar)
Sayfayı Yazdır
(Installer Selectable Options CONT'D)
Auxiliary Input Polarity - The auxiliary input (green wire) is normally activated by
applying a positive voltage to the wire. To activate by connecting to ground
(negative), move the jumper from the "AUX-POS" pins to the "AUX-NEG" pins.
Auxiliary Input Function - The auxiliary input (green wire) allows activation by an
external source of either the Horn or the Manual push-button functions. This input is
usually wired into the vehicle horn switch. The wiring diagram on page 7 shows two
connection examples. NOTE: Permanent disconnection of the vehicle horn is NOT
recommended.
The siren is factory shipped with the auxiliary input option defaulted as the Horn
function (on only one of the "AUX" pins). To utilize the auxiliary input as the Manual
function instead of the Horn function, move the "AUX" jumper from one pin onto
both of the pins.
Two-Tone – The Thunder sound can be replaced by a Two-Tone sound by moving
the "TT" jumper from one pin onto both of the "TT" pins.
Thunder Disable - The Thunder function can be completely disabled by moving the
"TD" jumper from one pin to both pins. This will also disable the Two-Tone function
used when the manual button is pressed while the mode switch is in the Thunder
position.
Pursuit Disable - The farthest right slide switch position (L3) will normally activate the
siren output in the wail mode, along with all three light functions. Automatic
activation of the siren. If you prefer to NOT have the siren automatically activated
when the slide switch is moved to position three, move Pursuit Disable jumper onto
only one pin.
8 second timed gun lock release (S4) - The amplifier is shipped with the fourth push
button (S4) as a standard on/off button. It can be optionally selected to stay
activated for only 8 seconds when pressed. To change button (S4) to a timed
unlock remove the Gun Lock jumper and place it only on one pin.
Speaker Disable (Audible beep disable) - The audible beep heard when the light
control buttons on the siren are pressed can be disabled. If you move the Speaker
Disable jumper from both pins onto only one pin, the audible beep will cease.
-3-