Galls K9 Partner Kullanım Kılavuzu - Sayfa 8
Kapı açma sistemi Galls K9 Partner için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Galls K9 Partner 20 sayfaları. Power door opener
Sayfayı YazdırK9 Partner Power Door Opener System with PowerTouch Remote Control
Installation: Actuator and Linkage Rod
1) Locate the Door Latch Linkage Rod
2) Select mounting location for actuator. *Note: Actuator Rod MUST move in a linear
(straight) direction, or parallel to the linkage rod.
3) Install the actuator rod into the plastic clip on actuator. (Diagram 8d) The bent end of the rod
is pressed into the plastic clip. To decrease the distance of the pull, the plastic clip can be moved
to the second hole.
4) Bend the rod to make the adjustment required to achieve a straight or linear pull of the
actuator. This is a critical adjustment to prevent binding and eventual failure of the actuator.
5) Install the Rod Keeper Bracket on the rod. (Diagram 8a) Adjust location of rod keeper
bracket to correct position for mounting door latch linkage rod. Tighten both allen screws.
Diagram 8a
50 Newton
Actuator
Notes:
1) Mount rod & plastic clip toward outside metal door skin. Diagram 8c
2) Mount actuator using bolts or screws and bracket. Each vehicle will have a
different mounting location.
3) The direction of the actuator pull can be reversed by reversing the polarity
of the green and blue wires.
4) Tighten both allen screws on the rod keeper securely
Diagram 8c
Note: Some vehicle door latches are more difficult to open than others. This is due to different
manufacturing tolerances, age and wear on vehicle. To enhance the pulling power of the actuator,
you can add springs, which can be purchased at a local hardware store. The spring must have enough
force to assist the actuator when pulling the latch open, but not be so strong as to keep the latch from
closing properly.
Start Position of Rod - Pull
Spring Stretched
Actuator
Door Latch - Closed
Rod MUST move in a linear
(straight) direction. Bend rod
to adjust for this movement
Inside Door Panel
Metal Bracket
Bolts or Screws
Actuator
Actuator Rod & Plastic Clip
Outside Metal Door Skin
Diagram 8e
Rod Keeper
Screw
Spring(stretched)
Door Lock Linkage Rod
Rod Keeper
Allen Screws
Actuator Rod
Diagram 8d
Move plastic clip
to 2nd hole for
1/2" travel
Actuator
Start Position of Rod - Pull
Spring Stretched
Actuator
Door Latch - Open
Manual C840.N2
Rods MUST be parallel
to prevent binding of the
door lock motor. Motor
will fail if the rod binds
when pulling door
linkage rod!
Diagram 8b
Allen Screws
Door Lock
Linkage Rod
Rod Keeper
Actuator Rod
Leave plastic clip
in 1st hole for
3/4" travel
Rod Keeper
Diagram 8f
Rod Keeper
Screw
Spring
Page -8-