Highway Equipment Company NEW LEADER G4 Nasıl Kontrol Edilir - Sayfa 5

Serpme Highway Equipment Company NEW LEADER G4 için çevrimiçi göz atın veya pdf Nasıl Kontrol Edilir indirin. Highway Equipment Company NEW LEADER G4 13 sayfaları. Spread pattern

Sayfayı Yazdır

Spinner assembly has NOT been adjusted at the factory. Before spreading

material, spread pattern tests must be conducted to properly adjust the spread

pattern. A Spread Pattern Test Kit, part number 300508, is available for this

NOTICE!

purpose. THE MANUFACTURER OF THIS SPREADER WILL NOT BE

LIABLE FOR MISAPPLIED MATERIAL DUE TO AN IMPROPERLY

ADJUSTED SPREADER!

It is recommended that spread pattern tests be conducted prior to each spreading season, after any

spreader maintenance, and periodically during the spreading season. Spread pattern tests must be

performed for each product and application rate.

Spread pattern is affected by many factors. Among the more significant of these are:

1. Spinner speed.

2. Material weight per cubic foot.

3. Material flow characteristics.

4. Rate of delivery of material.

5. Point of delivery of material on spinner discs.

6. Balance between deliveries to both spinner discs.

7. Angle of the distributor fins on the spinner discs.

8. Cleanliness of the spinner fins and discs.

9. Level of spreader.

10. Wind and humidity.

11. Spacing of swaths.

12. Wear on spinner fins.

Since many of these factors will vary for each job, trial and experience must be used to determine the

adjustments which must be made to obtain the spread width and spread pattern desired. The following

instructions are given to cover the adjustments available and the effect that each will have on the spread

pattern.

ADJUSTING THE SPREAD PATTERN

HIGHWAY EQUIPMENT COMPANY

305438-SP-A

Page Rev. A