highwood Kepner Montaj Kılavuzu - Sayfa 2

Dış Mekan Mobilyaları highwood Kepner için çevrimiçi göz atın veya pdf Montaj Kılavuzu indirin. highwood Kepner 2 sayfaları. Bench

Before you start

This assembly can be done by one person alone, however it is much

easier when two people work as a team.

STEP 1

Connect Leg Assembly to the Seat Base

Position and hold Leg Assembly (A) and Seat Base (B) together,

and attach by inserting two Carriage Bolts (C) into the pre-drilled

holes on the side of the Seat Base as shown in Image #1. Repeat on

other side.

Note: Holes are pre-drilled for the Carriage Bolt to pass through,

but use a hammer to ﬁrmly tap the bolt end several times so that the

square neck sinks into the highwood

Attach Flange Nut (D) to the carriage bolt from the inside of

seat base and tighten so that it further pulls the bolt neck into the

material leaving just the dome ﬂush with the surface.

Image #1

Using two Wood Screws (E) ﬁnish attaching the Leg Assembly

to the Seat Base by inserting the Wood Screws into the pilot

holes as shown in Image #2. Repeat on other side.

Image #2

For information on Care and Cleaning your highwood

Visit our Website and Facebook page to see more highwood

Image #2

material.

www.highwood-usa.com • www.facebook.com/highwoodUSA

STEP 2

Attaching Seat Braces

With the bench ﬂipped upside down, and the Highwood Logo

facing you, position Seat Brace (G) under the front leg of the

seat and attach it to the leg and seat base using two 2-1/4"

screws (F) in the pilot holes as show in Image #3 below.

Repeat on other side.

Image #3

Enjoy your

"Kepner" Bench!

product visit www.highwood-usa.com/care.html

Image #4

products!