highwood Brockton Montaj Kılavuzu

Dış Mekan Işığı highwood Brockton için çevrimiçi göz atın veya pdf Montaj Kılavuzu indirin. highwood Brockton 2 sayfaları.

TOOLS

• Heavy duty hammer

• Level

• Flathead screwdriver or pliers

• Small block of wood

COMPONENTS

Part

Description

(A)

Lamppost

(B)

Metal ground stake (no dig)

Before you start

IMPORTANT Check for underground services with your local

authorities BEFORE installation of this product. They will

typically mark out underground cables/gas etc at no charge.

The highwood

lamppost is pre-assembled and comes with a stable top "shelf" that allows

you to mount any type of lamp/lantern (whether directly into the lamppost neck or by using

any mounting bracket that the lamp would come with).

Qty

Your highwood

lamppost can carry wiring to the lamp – please use a standard wood-drill

bit in order to slowly and carefully put a hole in the ﬂat-top of the lamppost. The wiring

that you use should be fully shielded... no exposed wires. Thread the wiring through from

the ground, up through your lamppost and then out of the hole that you have drilled in the

top and into the lamp. Note that your highwood

you to either (a) attach a lamp directly to the shelf (screw down into the top) OR (b) attach

an adapter which will then receive your chosen lamp.

STEP 1

Install metal ground stake

Measure and mark the half way point on Metal ground stake (B) as shown in Figure

1 below. Place Stake (B) in desired location and carefully use a hammer to drive it

into ground. Use level to make sure the stake is straight and plumb. Adjust as needed

and ﬁnish driving it into the ground using a small block of wood on top of stake as

shown in Figure 2 below. Install no deeper than the half-way point.

Fig. #1

ASSEMBLY GUIDE

"Brockton" Lamppost

lamppost has a ﬂat top in order to allow

Fig. #2

LMPT1 [10.11.12]