Coral 817 Kurulum Kılavuzu - Sayfa 8

Su Sebili Coral 817 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Coral 817 8 sayfaları. Ion exchange water softener

Sayfayı Yazdır

To Re Set the Control

Only to be done when necessary.

1. Press and hold SET and DOWN together for 5 seconds.

2. H0 and the system's resin volume for model will be displayed.

3. Press and hold the square set button for 5 seconds, three dashes should

4. Use the up or down arrows to select the correct or nearest media volume

5. Press the set button to accept this setting.

6. Refer to the earlier set up guide for the other settings.

Identifying your Softener.

Your softener will have a identification label fixed to the outer carton and the control valve,

this will look similar to the picture shown here.

The information listed can be read as follows:

4202035013

SNo 08090137

Mis

0919-255-760

Identify the settings relevant to your softener from the chart below by looking at the vessel

size and controller type.

Typical settings for 740 & 760 softeners,

Vessel Size

Media Volume to program (litres)

Time of day (HH:MM)

Day of week (DAY)

Time of regeneration (HH:MM)

Calendar override days 740

Calendar override days 760

Regen interval if P4 set to 0 (740 ONLY)

Salt amount (gms)

Capacity (Kg) 740 control (cannot change)

Capacity (Kg) 760 control

Hardness in ppm CaCO3

then appear on screen.

of your softener.

Stock Number:

Serial No:

Id Code:

Configuration:

Manufacturers part number.

Serial No.

Softener type identification code.

Vessel size, Valve type & Controller type.

613 1012 817 822 919 735 1023 835 935 1035

10 15

Set on site / Factory set default 2.00am

P4 14

14 14

P7 0.3

0.5 0.5 0.8 0.8 1.2

P7 0.2

0.5 0.5 0.7 0.7 0.9

- 8 -

15 20

Set on site

14 14

Set on site if required

1.2 1.5 1.6 2.1

1.1 1,3 1.5 1,8

Set on site 760 only

20 30

14 14

Soft 001a