Galvin Engineering CLEVAKIT1CP Kurulum Talimatları Kılavuzu - Sayfa 3

Sıhhi Tesisat Ürünleri Galvin Engineering CLEVAKIT1CP için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Galvin Engineering CLEVAKIT1CP 6 sayfaları. Hand shower kit

Sayfayı Yazdır
Product Installation Guidelines

INSTALLATION

INSTALLATION COMPLIANCE: Galvin Engineering products must be installed in accordance with these
installation instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory
requirements. Water and/or electrical supply conditions must also comply to the applicable national and/or
state standards. Failing to comply with these provisions shall void the product warranty and may affect the
performance of the product.
38
DRILL 2 HOLES
Ø8x50 DEEP
2275mm ABOVE
THE FLOOR
1. Top Flange
Mark the height of the top flange centre point by
measuring vertically 2275mm above the floor. Then
measure approximately 150mm horizontally to the
left or right (depending on the position of the
shower recess) of the centre of the existing supply
fitting. Drill 2 holes Ø8 x 50mm deep, 38mm
horizontally apart to suit the top flange.
3. Mount the shower arm
Attach both the wall flanges using the plastic star
plugs and self-tapping screws supplied (these
fasteners may not be appropriate for all wall
materials. If this is the case, other fastening
systems will have to be sourced by the installer).
© Galvin Engineering Pty Ltd
Version 1, 1 June 2022, Page 3 of 6
2. Bottom Flange
Mark the position of the bottom flange's centre point
400mm below the top flange's centre point. Then mark
the two holes for mounting the bottom flange in a
similar manner to the top flange.
Note: The bottom flange is mounted in a vertical
orientation.
Important: the functionality of this product relies on the
accuracy of the vertical alignment between the top and
bottom flanges.
4. Attach the hose
When fitting the inlet hose, lay the arm against the wall
in the preferred 'resting' position, then tighten the
hose. The arm will tend to return to this position when
not in use.
th
Version 1, 25
May 2022, Page 3 of 6