Galvin Engineering Flowmatic TZ-FLOWSENC24 Kurulum Manüelleri - Sayfa 9

Sıhhi Tesisat Ürünleri Galvin Engineering Flowmatic TZ-FLOWSENC24 için çevrimiçi göz atın veya pdf Kurulum Manüelleri indirin. Galvin Engineering Flowmatic TZ-FLOWSENC24 11 sayfaları. Ss face plate w/ concealed 24v ac wall sensor

Sayfayı Yazdır

Product Installation Guidelines

5. Type of controller (left drop-down menu)

For the TZ-FLOWTAPC24 controller the 'Wave' or

'Proximity' selection may be used depending on the

application. Please do not change the selection to

the , 'Urinal', 'Pan' 'PB2' or 'Flusher'.

7. Choosing the suitable mode

- 'Wave' mode:

•

If a hand is detected, the water will start and keep flowing until the time set in the 'Run time' section will

pass or another 'wave' will appear in front of the sensor.

- 'Proximity' mode:

•

If a hand is detected, the water turns on for as long as the hand is there, up to a certain timeout value set

in the 'Run time' section.

- 'Urinal' mode:

•

When a user is first detected in front of the sensor, the cycle is triggered so that a timer starts when the

user leaves. At the end of this timed period, the solenoid valve is actuated to flush the urinal and the

cycle is then reset.

- 'Pan' mode:

•

When a user is first detected in front of the sensor, a timer starts. After a pre-set time, if the user is still

there, the sensor decides that a full flush will be required, otherwise, only a half flush will be triggered.

This flush happens a set time after the user leaves the immediate vicinity

8. Settings 'Hygiene flush'.

Set the required time for Hygiene flush and press

'Upload'.

Version 1.1, 30 April 2021, Page 9 of 11

6. 'Wave', 'Proximity' setting screens

contains the same setting parameters.

Run time (s) slider – to set the required

flow time.

'Detection threshold' slider – to set

sensing range. By setting smaller value

the detection distance is farther. Bigger

value is making the detection distance

shorter.

9. Connection menu.

By pressing the back arrow, the

connection screen will pop up.

The buttons allow to rename the

controller, set new PIN, disconnect, or go

to setting screen 'Next'.