Galvin Engineering Haws 8123-A Ürün Kurulum Manualline - Sayfa 5
Sıhhi Tesisat Ürünleri Galvin Engineering Haws 8123-A için çevrimiçi göz atın veya pdf Ürün Kurulum Manualline indirin. Galvin Engineering Haws 8123-A 5 sayfaları. Drench shower, wall mounted, pull rod, axion msr abs shower
Sayfayı Yazdır
`
TROUBLESHOOTING
1. No Flow.
2. Insufficient water flow
For more information about GalvinSafe
WARRANTY
The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty
Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied.
Galvin Engineering Pty. Ltd. hereby specifically disclaims all other warranties, express or implied, including but
not limited to the implied warranties of merchantability and fitness for a particular purpose.
Galvin Engineering Pty Ltd products are covered under our manufacturer's warranty available for download
from www.galvinengineering.com.au Galvin Engineering Pty Ltd expressly warrants that the product is free
from operational defects in workmanship and materials for the warranty period as shown on the schedule in
the manufacturer's warranty. During the warranty period, Galvin Engineering will replace or repair any
defective products manufactured by Galvin Engineering without charge, so long as the terms of the
Manufacturer's warranty are complied with.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for
breach of warranty, and Galvin Engineering Pty Ltd shall not be responsible for any incidental, special or
consequential damages, including without limitation, lost profits or the cost of repairing or replacing other
property which is damaged if this product does not work properly, other costs resulting from labour charges,
delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions,
chemical, electrical or any other circumstances over which Galvin Engineering has no control. This warranty
shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or
alteration of the product.
PROBLEM
®
1.
Check the main shut-off valve.
2. a. Verify minimum 210 kPa flowing
supply line pressure
b. Probable clogging of flow control due
to inadequate line flushing. Unscrew
showerhead off of elbow and clean
rubber flow control.
(Haws) products, see our website.
th
Version 3.1, 13
Aug. 2021, Page 5 of 5
REPAIR CHECKLIST