Coralife Super Skimmers Talimatlar Kılavuzu - Sayfa 2

Laboratuvar Ekipmanları Coralife Super Skimmers için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Coralife Super Skimmers 9 sayfaları.

Coralife Super Skimmers Talimatlar Kılavuzu
IMPORTANT SAFETY
INSTRUCTIONS
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
CAUTION
To guard against injury, basic safety precautions should be observed when
operating the unit.
WARNING
1. Never connect the Coralife Super Skimmer to any power source while
hands are wet.
2. Always unplug the unit from outlet or power source before installing,
replacing parts or doing product maintenance.
3. Never allow pump to run dry. Always keep pump submerged during
operation. Failure to keep pump submerged while in use may damage the
unit and/or cause unit failure.
4. Always leave a drip-loop in the pump cord to prevent water from running
down the length of the cord and reaching the power source or outlet.
5. For added safety, the pump should be plugged into a grounded three-
prong receptacle controlled by a GFI (Ground Fault Interrupter) circuit
breaker.
6. Make sure that the Super Skimmer is securely installed before operating.
PRE-INSTALLATION SETUP
NOTE: Prepare at least 5 gallons of "make-up water" to replace water
used by the Super Skimmer. (P2)
HANG-ON TANK MOUNT PLACEMENT
1. Allow a minimum 8" clearance between the aquarium and the wall.
NOTE: Hang-on tank mounting bracket for up to 1.125" tank mouldings.
2. Ensure that there is adequate unobstructed space for the pump inside the
aquarium (9"L x 4"W x 5"H).
SUMP HOOK-UP PLACEMENT
1. Verify that there is adequate
space for the super skimmer
in/or outside of the sump
(12"L x 10"W).
2. Allow a minimum 1" clearance
between the underside of
the stand and the top of the
skimmer. Make sure there is
enough space to remove/slide
the collection cup out of the
sump.
POWER
SUPPLY
CORD
AQUARIUM
TANK
DRIP
LOOP

PARTS DIAGRAM

1.0
Collection Cup Lid
Collection Cup
Collection Cup
Drain Plug
(Model 125 & 220 only)
Collection Cup
Drain Tubing
(0.25" I.D. clear)
(Model 125 & 220 only)
O-Ring
Main Chamber
1 x - 0.75" Screw
3 x - 1.125" Screw
Output Tubing
Air-inlet Silencer
with Tubing
(0.25" I.D. clear)
Venturi Chamber
Debris Strainer
Short Flexible Tubing
(0.625" I.D.)
Long Flexible Tubing
(0.625" I.D.)
Flow Control Valve
(Model 65 only)
Water Pump
(650 - 750 gph)
Mounting Bracket J
(Model 65 only)
Mounting Bracket F
(Model 65 only)
Sponge (Black)
(Model 65 only)
Filter Pad (White)
(Model 65 only)
Bubble-production
Diffuser
(Model 65 only)
Round Diffuser
Sponge
(Model 125 & 220 only)