Galvin Engineering GalvinAssist CLEVA055 Kurulum Manüelleri - Sayfa 4

Banyo Armatürleri Galvin Engineering GalvinAssist CLEVA055 için çevrimiçi göz atın veya pdf Kurulum Manüelleri indirin. Galvin Engineering GalvinAssist CLEVA055 4 sayfaları. Hand shower, inverted rh t 700 x 1100 ss hygienic g/rail, clevacare shw - low

Sayfayı Yazdır

Product Installation Guidelines

5. Check Shower for operation and leaks

Check the hose is securely connected. Turn on water supply, the shower should now be working. Once

installation is completed and the unit must be tested for any leaks.

To comply with backflow prevention standards, the hand spray must hang at least 55mm above the

floor provide an 'air-gap' (See Figure 1). If the hand piece lies on the floor, then an appropriate

backflow prevention device must be installed.

TROUBLESHOOTING

PROBLEM

Water is not flowing or

inconsistant flow

WARRANTY

The warranty set forth herein is given expressly and is the only warranty given by the Galvin

Engineering Pty Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties,

express or implied. Galvin Engineering Pty. Ltd. hereby specifically disclaims all other warranties,

express or implied, including but not limited to the implied warranties of merchantability and fitness for a

particular purpose.

alvin Engineering Pty Ltd products are covered under our manufacturer's warranty available for

download from www.galvinengineering.com.au Galvin Engineering Pty Ltd expressly warrants that the

product is free from operational defects in workmanship and materials for the warranty period as shown

on the schedule in the manufacturer's warranty. During the warranty period, alvin Engineering will

replace or repair any defective products manufactured by Galvin Engineering without charge, so long as

the terms of the

anufacturer's warranty are complied with.

The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive

remedy for breach of warranty, and Galvin Engineering Pty Ltd shall not be responsible for any

incidental, special or consequential damages, including without limitation, lost profits or the cost of

repairing or replacing other property which is damaged if this product does not work properly, other

costs resulting from labour charges, delays, vandalism, negligence, fouling caused by foreign material,

damage from adverse water conditions, chemical, electrical or any other circumstances over which

Galvin Engineering has no control. This warranty shall be invalidated by any abuse, misuse,

misapplication, improper installation or improper maintenance or alteration of the product.

CAUSE

Shower arm is blocked with

debris.

Version 1, 2

June 2022, Page 4 of 4

Version 1, 2 June 2022, Page 4 of 4

RECTIFICATION

Remove debris from shower arm.