AGS Carbon Monoxide Kurulum Operasyon ve Bakım - Sayfa 5

Gaz Dedektörleri AGS Carbon Monoxide için çevrimiçi göz atın veya pdf Kurulum Operasyon ve Bakım indirin. AGS Carbon Monoxide 12 sayfaları. Parksafe gas detector

Sayfayı Yazdır

Installation, Operation & Maintenance

Access & Mounting

Unpack all the parts! Designed for surface mounting, it must be installed by a licensed, insured contractor.

Carefully remove the front cover of the unit by removing the four screws with a screwdriver. Remove the foam, this is

used for transit purposes only. Using the rear cover - mark the screw holes to the wall. If mounting direct to wall -

ensure the wall surface is flat to prevent base distortion. There is a 0.79" diameter hole for cable entry. Position as per

the recommended heights and in accordance with applicable local/national regulations. After executing the mounting,

connections and ID switches – secure the front cover.

Carbon Monoxide (CO) gas

Nitrogen Dioxide (NO

) gas

Internal Board Overview

Be careful when creating access for cables – Damage to circuit boards will void any warranty!

Any damage attempting to remove the circuit board parts may void any warranty!

Detectors must be earthed/grounded for electrical safety and to limit the effects of EMC or R/F interference!

For MODBUS communications, a shielded cable is used!

Do not remove the Gas Sensor Module when the detector is powered!

Rev: 11

0421

Breathing Zone - 1700mm (5ft 6") from ground level.

Low Level - 300mm (1ft) from ground level.

Parksafe Gas Detector