Hikari H93S Kullanım Kılavuzu - Sayfa 9
Dikiş Makinesi Hikari H93S için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Hikari H93S 20 sayfaları. Electrical control box
Sayfayı Yazdır
Long press"
press"
"key exchange to "3"， press"
"no"】 ，and press"
8. Pattern design setting mode：
Under normal sewing mode ， long press
press
key exchang to d1-d9 pattern，choose your pattern no. and press S for setting，the
screen appear "1
3.0 01"， now setting the stitching and gauge data for first stage， press left/right key
to select setting data；after setting one stage，press left/right key move to left data，press +/- key move
to other data setting， if current stitch is zero, can not go on next stage setting； After finish all the data of
stitching and gauge，press
and no save。Press
Remark：
（1） The function is used for setting pattern design， could setting 9 kind of patterns， 16 teams each
patterns；Under sewing mode， the pattern is as gauge。
（2） Pattern sewing mode， if stopping during sewing， after press reverse button， the pattern sewing
will be begin from zero。 （fit for corner bend）
III.System parameter table
NO
Project
P-01
Sewing speed
P-02
Soft start function
Fixed-length
P-04
sewing speed
Zero pitch correction
P-06
value
Positive
needle
P-07
distance
correction
value
Anti-needle distance
P-08
correction value
Back stitch speed
P-09
limitation
Set the length of the
P-10
stitch from the set
number
"key enter parameter interface ， enter parameter no. "P79", appear "0" ，
" key for resetting original parameter。
key for saving and return back to "d1" interface，press
key return back to normal mode。
Set sewing speed
Sewing few stitches at sewing start function
0：Invalid 1~9：Soft start stitches
seam
Set fixed-length seam sewing speed
When the needle pitch is set to 0mm,fine the value
so that the actual sewing needle pitch is zero
Magnification positive sewing distance
(Sewing needle fixed distance)
Enlarge reverse stitches Distance Scale (Sewing
needle fixed distance)
can keep needle from breaking while backstitching
0:Set the number of stitches to set the value
1:When the length is set to self-made, the number
is the number of the pattern, that is, the total
"key will appear "yes" 【 press"
key 2 seconds ， the screen appear "d1" ，
Content
6
"key will adjust to
key for exit
The
Setting
defaul
level
range
t
value
200~5000(rp
4100
m)
0~9
2
200~4000(rp
3000
m)
50~150
100
50~150(%)
100
50~150(%)
100
500~1500
800
0/1
1
1
1
1
2
2
2
1
1