Corally C-00251 Hızlı Başlangıç Kullanım Kılavuzu - Sayfa 5
Oyuncak Corally C-00251 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kullanım Kılavuzu indirin. Corally C-00251 19 sayfaları. 1/10th scale elctronic ready to run
Ayrıca Corally C-00251 için: Hızlı Başlangıç Kullanım Kılavuzu (17 sayfalar)
Sayfayı Yazdır
LIPO BATTERY SAFETY PRECAUTIONS
• Follow and respect the manufacturer's instructions for use
• It is important to check that your ESC is set to LIPO if you are using a LIPO battery. Failure to comply with this instruc-
tion will result in increased battery discharge and may cause fire and damage to persons and property.
• When charging or storing LiPo batteries always use LiPo Safety Bag (Flame retardant).
• Always respect the maximum rate and voltage specified by the battery manufacturer.
• Charge the LIPO battery outdoors or in a ventilated area away from flammable objects and surfaces.
• NEVER leave your LiPo battery unattended while charging.
• If the battery swells during charging, stop charging immediately and disconnect the battery from the charger. Leave
the battery outside for a few hours and observe. Then recycle the battery according to the instructions of your country/
region. Never dispose of a LIPO battery with domestic waste.
• Before recycling your defective battery, it must be neutralized. Take a plastic container, fill it with water and add a lot of
salt until the water becomes opaque. Place the LIPO battery in the water and leave for 24 hours. Check with a voltme-
ter that the voltage is 0.0V. Then recycle the battery according to local regulations.
• Never charge a damaged or inflated battery.
• Never discharge the battery cells below 3.2V.
• Always use the appropriate balancer/charger when charging your LiPo battery pack.
• When the battery is empty, check the temperature of the battery before charging it.
If the battery is very hot, wait until it cools before charging it.
• Never charge a very hot battery as this may cause an explosion or fire.
• When the battery is empty, recharge it immediately. Do not store an empty battery, the battery will continue to dis-
charge, it will fall below the minimum voltage and become unusable.
KIT CONTENT (Depends on the selected model)
Transmitter
REQUIRED FOR OPERATION (Not included)
4x AA Batteries
for the Transmitter
Hex Drivers
1.5mm
2.0mm
3.0mm
RTR Model (Chassis with Body)
2S - 7.4V LiPo Battery
3S - 11.1V LiPo Battery
Cross Wrench
User Guide
Charger
Silicone Oil
(for maintenance)
5