AGS Mini Merlin LPGCO v2 TX Kurulum, Çalıştırma ve Bakım Kılavuzu - Sayfa 9
Gaz Dedektörleri AGS Mini Merlin LPGCO v2 TX için çevrimiçi göz atın veya pdf Kurulum, Çalıştırma ve Bakım Kılavuzu indirin. AGS Mini Merlin LPGCO v2 TX 16 sayfaları. Dual gas detector
Sayfayı YazdırMini Merlin Installation, Operation & Maintenance
Wiring – Pilot Water Heater & Boiler Limit Breaker
The device can be used to directly shut the pilot of a water heater in an alarm or power failure state using a product
from Field Controls. The BMS terminals may also be used to connect to a home alarm system.
Wiring – Remote Shut Off
When using this input, only the mains utility output shall de-energize. If you are using the CO or NG relay to shut down
a boilers external limit circuit, you will need to wire the input in series with the relay output.
Auto Reset & Buzzer Switches
In the event of a power loss – the mini-merlin will restart
automatically when power is restored.
The buzzer will sound every 15 seconds during pre-alarm
and continuously at alarm level.
This is the factory default condition.
Rev: 03 05-22
Your mini-merlin can be integrated with remote devices with an open /close circuit via
the Remote Shut-Off volt free switch terminal.
This terminal has a factory fitted link installed. This terminal is normally closed and will
alarm when energised open - isolating the gas supply.
ON
OFF
In the event of a power loss – the mini-merlin will need to
be reset manually when power is restored.
This is the factory default condition.
The buzzer will not sound at any gas level.
9