Jacuzzi 67416-3D01Y Manuel - Sayfa 2

Sıhhi Tesisat Ürünleri Jacuzzi 67416-3D01Y için çevrimiçi göz atın veya pdf Manuel indirin. Jacuzzi 67416-3D01Y 5 sayfaları. Two handle roman tub faucet

Sayfayı Yazdır
ASSEMBLY INSTRUCTIONS
1
1-3/8 in. dia.
Diam. de 3,49 cm
1-1/8 in. dia.
Diam. de 2,85 cm
Drill holes in FINISHED DECK per diagram.
NOTE: This kit is intended for installation up to
1-1/4 in. thick.
4
1
1
3
3
2
2
Place the spout assembly (1) onto the connector (2).
Be sure the spout assembly (1) is resting firmly on
the deck. Push down on spout assembly (1) and
tighten set screw (3) with Allen wrench
(Hex: 3.2mm, 4). Insert the cap (5).
QD86000
2
1
2
1-3/8 in. dia.
Diam. de 3,49 cm
3
Remove connector (1) from the middle body. Adjust
the washers (2) and mounting nut (3) to the bottom
of middle body.
5
2
3
5
5
4
4
4
5
Unscrew the set screws (1) from the handle
assemblies (2)with Allen wrench(Hex:2.5mm,6) and
remove the handle assemblies (2) from the valve
bodies. Loosen the flanges (3) from the valve bodies.
Adjust the washers (4) and mounting nuts (5) to the
bottom of valve bodies.
1
6
1
2
3
4
5
2
3
4
4
1
2
2
3
3
From underneath the deck, insert the middle body
with the rubber washer (1), metal washer (2) and
mounting nut (3) through hole. From above, thread
the connector (4) onto middle body. Tighten the
mounting nut (3), so that the connector (4) sits flush
to the surface of working area. Note: The middle body
must turn to the direction as shown in the diagram.
6
4
1
2
3
From underneath the deck, insert the valve body with
the rubber washer (1), metal washer (2) and mounting
nut (3) through hole on the right (cold) side. From
above, thread the flange (4) onto valve body. Tighten
the mounting nut (3), so that the flange (4) sits flush
to the surface of working area. Then insert the other
valve body through holes on the left (hot) side and
install in the same way. Note: Hot side end valve is
labeled.