Coram OPTIMA Hızlı Başlangıç Kılavuzu - Sayfa 2

Banyo Armatürleri Coram OPTIMA için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Coram OPTIMA 2 sayfaları. Corner entry shower enclosure

Sayfayı Yazdır
Check contents of pack before installation.
If there is anything missing, contact our Customer Careline
for assistance.
CUSTOMER CARELINE: 01746 713410
PN3230
PN50181
8
PN3225
PN50180
16
32mm
PN3222
PN40093
6
10mm
PN4748
PN60058
14
PN6020702
PN40095
2
PN40154/6
PN50186
8
1
=
=
=
100mm max
Drill holes in both wall channels (PN10453) at points shown using a 4.5mm drill bit, through the edge shown and in the grooves.
Ensure shower tray is level in all directions.
2
Model 760=
Model 760=
=
=
735mm Min.
735mm Min.
760mm Max.
760mm Max.
Model 800=
Model 800=
775mm Min.
775mm Min.
800mm Max.
800mm Max.
Model 900=
Model 900=
875mm Min.
875mm Min.
900mm Max.
900mm Max.
Place wall channels on tray as shown (to fit within the dimensions above), ensure they are vertical. Place masking tape against the
wall before marking the drill hole positions, this will prevent the drill bit slipping.
Drill 6.5mm holes – 30mm deep, insert wall plugs and apply sealant to back of wall channels. Fix to walls using 32mm screws
and screw caps.
2
2
1
1
2
PN10453
1/1
100mm max
ø 4.5
mm
ø 6.5
mm
3
X
mm
Insert a side panel into a wall channel. If required mark and cut the bottom rail as shown.
Measure the cut rail and cut the remaining top and bottom rails to the same length.
PN10453
4
(a) Fit the top and bottom corner mouldings and fix using 32mm screws. (b) Push fit the corner moulding cover caps.
(c) Ensure enclosure sides are vertical. Drill inside wall channels using 3mm drill bit where shown. Do not drill too deep.
Fix using 10mm screws and screw caps.
5
a
32mm
(a) Fit the door handles ensuring the supplied handle washers are used on each side of the glass. (A chrome finish
handle is supplied with all frame finish options) DO NOT OVER TIGHTEN, finger tighten only.
(b) If needed, trim door seals to length. Trim the top and bottom corners of each door seal as shown. Push-fit the door
seals onto back edge of each door (opposite side to door handle).
(c). Push-fit the magnetic seals onto the other side of the doors. Ensure the seals meet as shown.
X + 40mm
a
b
c
32mm
x
x
x
32mm
b
c
20mm
PN40156
PN40154
=
=
=
=
x
ø 3
mm
x
10mm
x
6
Hang the doors on to top
track of the frame. Ensure
the seals meet as shown.