Coram TUBULAR SHOWER PANELS Hızlı Başlangıç Kılavuzu - Sayfa 7

Banyo Armatürleri Coram TUBULAR SHOWER PANELS için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Coram TUBULAR SHOWER PANELS 9 sayfaları.

12
Y
Approx.
100mm
Ensure that the end of the second panel is vertical.
Carefully place the second panel bracket on to the glass, approximately 100mm from
the edge (depending on your installation).
Carefully measure the distance 'Y' between the wall bracket assembly and the panel
bracket.
15
Push-fit the top caps onto the wall channels.
13
a
b
a: If required, trim the strut to length: Y + 86mm.
b: Push-fit the end cap onto the untrimmed end of the strut.
16
Outside
From outside only, apply silicone sealant along the bottom of the panels as shown.
Y + 86mm
Untrimmed
end of strut
14
Position the strut into the wall bracket assembly and the panel bracket.
Ensure the panel is vertical and tighten the grub screws onto the strut bracket using the
3mm Allen key.
1
2
Inside
PAGE 7