Coram Showers OPTIMA INLINE PANEL Talimatlar Kılavuzu - Sayfa 4

Duş Kabinleri Coram Showers OPTIMA INLINE PANEL için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Coram Showers OPTIMA INLINE PANEL 6 sayfaları.

Sayfayı Yazdır
INLINE ONLY
3
a
PN80499
c
a: Insert both 'pivot brackets' (PN80499 & PN80524) onto the strut tube (PN10937).
Note: The strut tube may need trimming to length to suit your requirements.
b: Tighten both 'pivot bracket' grub screws onto the strut tube. IMPORTANT: Ensure the pivot brackets 'pivot' horizontally.
c: Position the strut assembly onto the panel and against the wall.
d: Ensure the strut is level and mark the position of the wall pivot onto the wall. Remove the strut from the panel.
4
a
a: Remove the wall pivot from the strut.
b: Unscrew and remove the wall bracket from the end of the wall pivot.
c: Drill a 6.5mm hole 30mm deep in the middle of the position marked on the wall.
d: Push fit a wall plug and attach the wall bracket to the wall using a 32mm screw.
e: Screw the wall pivot onto the wall bracket. IMPORTANT: The wall pivot MUST pivot horizontally, if it does not, loosen and slightly rotate the wall
bracket refit the wall pivot and check again.
4
Only fit the wall
bracket in the
position shown
(plan view of the
enclosure).
PN10937
PN80524
PN80499
d
b
d
b
Wall bracket
e
32mm
INLINE WITH SIDE PANEL
c
Only fit the wall
bracket/s in the
position/s shown
(plan view of the
enclosure).
ø 6.5
mm