GAM TwinSpin II Manuel

Endüstriyel Elektrik GAM TwinSpin II için çevrimiçi göz atın veya pdf Manuel indirin. GAM TwinSpin II 2 sayfaları. Variable speed double pattern rotator

Sayfayı Yazdır

The Great American Market (GAM) - Home

INTRODUCTION

Congratulations on your new TwinSpin II. It will add an exciting new dimension to your pattern

projections: motion. Now you can create dynamic special effects quickly and easily.

PREPARING THE FIXTURE

Before inserting patterns or a TwinSpin II in your fixture, it is important to align the lamp. Position it

in the reflector so that the circle of light is as smooth and even as possible. When the field of light is

truly flat, it will appear a tiny bit darker in the center (this is an optical illusion).

When the lamp is positioned too far into the reflector, the center of the field will look hot. When the

lamp is positioned too far back out of the reflector, the center will be dull and shadowed and the

outer rim will look bright and harsh. 'Hot spots' cause premature warping of the patterns and may

damage delicate designs.

INSERTING PATTERNS IN THE TWINSPIN

With TwinSpin II lying on a flat surface, center a pattern in the shallow well on the lip of the circular

opening. Then secure with a retaining ring.

Begin by pushing one end of the ring into the groove in the corner of the lip. Hold firmly in

place with your finger, pressing the ring against the pattern.

Holding the ring firmly, work the ring around until it is all in place .

Finally, allow the hooked end to snap into place. To avoid pinching your finger, hold a small

screwdriver straight against the wall of the lip near where the notched end will land. You may

press the ring down gently with your finger to make sure it is tight all the way around. Turn

TwinSpin II over and repeat on other side.

Inserting retaining ring

TIP

When using older warped patterns, be sure they are bent away from each other in the TwinSpin so

they can't catch on each other while rotating.

INSERTING TWINSPIN II IN THE FIXTURE

First, be sure that the lamp is properly aligned. Then slide the TwinSpin II straight down into the iris

slot just in front of the pattern holder. Be sure it is seated straight and as far down as it will go.

Secure the TwinSpin II cord so it does not contact the fixture housing.

CONTROL

USING LINE VOLTAGE - You can plug your TwinSpin II transformer directly into any 120V AC line and

the patterns will rotate at full speed.

1 of 2

http://www.gamonline.com/catalog/twinspin/instruct.php

8/2/04 3:02 PM