AFL FlexScan FS300 Hızlı Referans Kılavuzu - Sayfa 16
Teşhis Ekipmanları AFL FlexScan FS300 için çevrimiçi göz atın veya pdf Hızlı Referans Kılavuzu indirin. AFL FlexScan FS300 20 sayfaları. With smartauto and linkmap
Sayfayı Yazdır
Source Settings and Features
1
1
Touch to enable/disable light source. RED Laser
indicates that source is ON.
A
2
Touch to select test mode: Wave ID, CW, Tone
2
(270 Hz, 330 Hz, 1 kHz, 2 kHz).
– Select Wave ID mode for fastest loss
measurements. While in this mode, the
FlexScan source transmits wavelength
information, enabling a Wave ID power meter
to synchronize and measure power at received
wavelength(s).
– Use CW mode to generate continuous wave
light at a single wavelength.
– Generate Tone for fiber identification (270 Hz, 330 Hz, 1 kHz, 2 kHz).
3
3
Touch to select test wavelength: 850 nm, 1300 nm, 1310 nm, 1550 nm.
Power Meter Settings and Features
4. If used with non Wave ID source, touch to select wavelength. If used with Wave ID source, power meter
4
automatically synchronizes to and indicates received wavelength(s).
5
5
Hold to store new reference(s) at received wavelength(s). Touch Ref/Set to view stored reference(s).
6
6
Touch to toggle between power (in dBm or Watts) and loss (dB) mode.
Note: Power meter detects and indicates fiber identifying tones when used with a light source capable of
generating a modulated Tone signal.
Light Source and Power Meter Operation
6
5
4
A
1
2
16
3