AFL IDEAA 144F Kurulum Talimatları Kılavuzu - Sayfa 8

Muhafaza AFL IDEAA 144F için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. AFL IDEAA 144F 14 sayfaları.

DISTRIBUTION CABLE INSTALLATION - MPO PIGTAIL SPLICING

When a non-connectorized distribution cable is utilized a MPO pigtail may be spliced onto the distribution cable.

Note: For distribution cable entry from the bottom of the cabinet, reference the Cable Installation section

of this document before continuing on to step 7.

1. Remove the five caps to expose the nuts on the top side of the 144F IDC.

2. Using a standard 216 style tool, or similar, remove the five nuts that secure the top plate

to the cabinet body. (Figure 10)

3. Remove the top plate.

4. Determine the appropriate compression fitting for the application.

5. Knock out the appropriate mounting hole to accommodate the compression fitting.

6. Install the appropriate compression fitting. Reference the Compression Fitting Installation section

of this document.

7. Using a standard 216 style tool, or similar, loosen the shipping screw from the swing down splice tray holder

in order to begin splicing. Do not remove this screw from the swing down tray holder. (Figure 4)

8. Prior to splicing, ensure that adequate slack for both the distribution fiber and the MPO pigtail fiber

is stored within the splice tray. Mark fibers for splicing.

9. Clean the fiber per accepted local practice using an approved fiber cleaner.

10. Follow accepted local practice for preparing and splicing distribution fibers and MPO pigtail fibers.

11. Once all splicing is complete, route the exposed fibers inside the splice tray. (Figure 8)

12. Replace the splice tray cover.

13. Secure the splice tray to the swing down splice tray

holder with the hook and loop band.

14. The fiber management rings on the side wall

of the IDC may be used for slack storage. (Figure 9)

15. Using local engineering practices, determine the

port to be used on the MPO field for the

MPO distribution cable.

16. Use local accepted practices to clean the connector

end face and plug the connector into

the appropriate port. (Figure 11)

17. Use the fiber management rings to route the

MPO pigtail fiber through the back side of the

144F IDC. (Figure 13)

18. Return the swing down splice tray holder to the upright

position and secure the shipping screw.

INSTALLATION INSTRUCTIONS

IDEAA

Distribution

Interior Distribution Cabinet

Pigtail

Figure 13

Specifications are subject to change without notice.