GAMA Electronics RF12V-2-ASL-NIS Kullanım Kılavuzu - Sayfa 2

Alıcı GAMA Electronics RF12V-2-ASL-NIS için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. GAMA Electronics RF12V-2-ASL-NIS 4 sayfaları.

WWW.GAMAINC.COM

Each transmitter has its own unique internal address along with the data as to which button is pressed and transmitted.

The receiver needs to be programmed to respond only to the specific transmitter it is intended to operate with. The

following steps configure the receiver to operate with a particular transmitter. Up to 30 transmitters can be programmed

to one receiver. Please read the entire programming procedure before starting. When the receiver enters program

mode, all previous transmitter addresses that were programmed will be erased from the receiver's memory.

1. Locate the pushbutton labeled "PROGRAM" on the receiver. Press and hold this button until the red LED next to the

program button illuminates (approximately 3 seconds). The receiver is now in the transmitter program mode. Release

the button. At this point all previously programmed transmitter addresses are erased from the receiver's memory.

2. To configure the receiver for a latching output, go to Step 4.

3. To configure the receiver for momentary output, press and release either button on the transmitter once and verify

that the red program LED extinguishes and then illuminates (blinks once). Proceed to Step 5.

4. To configure the receiver for latching output, press and release either button on the transmitter twice and verify that

the red program LED extinguishes and illuminates (blinks twice).

5. Repeat previous step for additional transmitters that will operate with this particular receiver. The red LED on the

receiver will extinguish and illuminate (blink) once for the first transmitter being programmed, twice for the second, three

times for the third, etc. The receiver will not respond to transmitters that have already been programmed. The first

transmitter that is programmed determines the receiver's relay operating mode.

6. The receiver will return to normal mode if no transmitter buttons are pressed for 5-seconds. The red LED on the

receiver will blink rapidly, then extinguish. The receiver is now in the normal mode of operation. This completes the

programming instructions. The receiver will retain all of its programming even when power is removed.

Program Switch

Long Range

Antenna Jack

Programming Instructions

PROGRAM

-12V

RF12V-2-ASL

Instruction Manual

Program LED

+12V

RF12V-2-ASL

GAMA Electronics, Inc.

www.gamainc.com

Auxiliary Switch

Leads

Page 2 REV A 03/09/20