GAMA Electronics RF340-DRC Kullanım Kılavuzu - Sayfa 2

Alıcı GAMA Electronics RF340-DRC için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. GAMA Electronics RF340-DRC 3 sayfaları.

RF340-DRC

Instruction Manual

WWW.GAMAINC.COM

Programming Instructions

Each keyfob transmitter has its own unique internal address that is transmitted whenever a button on the keyfob is

pressed. The receiver needs to be programmed to respond only to keyfob transmitters it is intended to operate with. The

following steps configure the receiver to operate with a keyfob transmitter(s). Up to 40 keyfob transmitters can be

programmed to one receiver. Please read the entire programming procedure before starting. Prior to programming the

receiver, verify that the receiver is connected to the input power.

1. Locate the pushbutton labeled "PROGRAM" on the receiver. Press and hold this button until the red LED next to the

program button illuminates (approximately 3 seconds). The receiver is now in the transmitter program mode. Release

the button.

2. Press and release any switchon the keyfob transmitter and verify that the red LED on the receiver extinguishes and

then illuminates (blinks once).

3. Repeat previous step for additional key fob transmitters that will operate with this receiver. The receiver will not

respond to transmitters that have already been programmed.

4. After 5-seconds of no switch being pressed on the transmitter(s) the receiver will return to normal operation. The red

LED on the receiver will blink rapidly, then extinguish. The receiver is now in the normal mode of operation. This

completes the programming instructions. The receiver will retain the programming even when power is removed.

5. To add additional transmitters to the system after the initial programming, repeat Steps 1 through 4.

To erase the receiver's memory of programmed transmitters, perform Steps 6 and 7.

Warning, this will restore the receiver to the original factory settings with no transmitters programmed.

6.Press and hold the program switch until the front panel LED illuminates.

7.Release the program switch and immediately press and hold the program switch a second time. The LED will start

blinking rapidly, then release the program switch. The receiver's memory is now cleared.

Page 2 REV A 06/06/18