AGS Merlin 1000S Kurulum ve Kullanım Kılavuzu - Sayfa 7

Laboratuvar Ekipmanları AGS Merlin 1000S için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. AGS Merlin 1000S 12 sayfaları. Gas utility isolation controller
Ayrıca AGS Merlin 1000S için: Kullanım ve Kurulum Kılavuzu (10 sayfalar), Kurulum, Kullanım ve Bakım Kılavuzu (10 sayfalar), Kurulum ve Kullanım Kılavuzu (16 sayfalar)

Sayfayı Yazdır
AGS Merlin 1000S Kurulum ve Kullanım Kılavuzu
Installation & Operation Manual

Switch Settings

Auto Reset
When power is restored after the power cut/ loss, the panel has to be restarted
OFF
manually. (Default)
This will instruct the system to restart automatically when power is restored after
ON
power cut/loss.
Building Management System Integration
[BMS SEL]. The panel can be integrated with a BMS to make or break a circuit when the gas is either on
or off, (valve open or valve closed).
This will tell the BMS whether or not power is being sent to the solenoid valve.
OFF
Signals the BMS when gas is on or gas is off. (Default)
Signals the BMS on a fault i.e. high gas levels detected, emergency shut-off
ON
activated etc.
Fan Switch Integration
[EM SEL].There is the facility to connect a Fan Switch.
A fan switch (Merlin FS1 or FS2 - sold separately) provides the facility to turn on fan(s) when the 1000S
panel is switched on and removes power to fan(s) when the switched off.
Instructs the system to shut down fan(s) and gas supply upon activation of
OFF
emergency shut off button(s). (Default)
Instructs the system to leave the fans on and shut off the gas supply only upon
ON
activation of emergency shut off button(s).
This option is not available if a Fan Switch is not installed.
Gas Fill Time and Prove Time
There are two switches located on the circuit board labelled [FILL TIME] and [PROVE TIME].
FILL TIME: Amount of time the gas valve opens to fill the gas line on power up or reset.
PROVE TIME: Amount of time the system tests the gas line for leaks on power up or reset.
FILL TIME
OFF
5 Seconds (Default)
ON
10 Seconds
Once the settings have been changed - remove power for 10 seconds.
Rev: 10
02-21
PROVE TIME
OFF
30 Seconds (Default)
ON
50 Seconds
Merlin 1000S
7