AgSense CROP-LINK Kablolama Talimatları - Sayfa 6

Kontrol Ünitesi AgSense CROP-LINK için çevrimiçi göz atın veya pdf Kablolama Talimatları indirin. AgSense CROP-LINK 8 sayfaları. 2012 - 14 soil moisture monitoring
Ayrıca AgSense CROP-LINK için: Kablolama Talimatları (10 sayfalar)

Sayfayı Yazdır

Power and Relay Wiring Instructions:

Choose one of these two ways to connect power to the cable that is

attached to our box :

Make sure power switch in the upper left portion of our circuit

board is turned on.

Once you have power applied to our unit, Call AgSense at

605-352-8350 to have the configuration sent to the unit so it will

start to read the flow meter.

Also, once power is applied to our unit, the configuration has been

sent to the unit, and water is flowing through the pipe, the GPS

light in the upper right corner of our circuit board will be blinking.

Optional: This unit has 2 relays that can be used to via the website to

remotely control other equipment.

- Relay/Wire Connections -

Relay 1 Common = Blue

Relay 1 Normally Open = Orange

Relay 1 Normally Closed = Yellow

Relay 2 Common = Blue/Black stripe

Relay 2 Normally Open = Orange/Black stripe

Relay 2 Normally Closed = Yellow/Black stripe

- AC powered units -

Black = 120v Power Input

Brown/Black stripe = Neutral

- DC powered units -

Red = 7-40v DC + Power Input

Red/black stripe = DC GND

Page 4