Frigidaire PLDB998AC1 Kullanım ve Bakım Kılavuzu - Sayfa 15
Bulaşık Makinesi Frigidaire PLDB998AC1 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Frigidaire PLDB998AC1 20 sayfaları.
Sayfayı Yazdır
Care and Cleaning
Burn
Hazard
Allow heating
element
to cool
before cleaning
the interior.
Failure to do so can result in
burns.
Outside--Occasionally
wipe with a mild
nonabrasive
detergent
and water.
Rinse and dry.
Models with Stainless
Steel Door--
Clean stainless
steel door and handle with
Stainless
Steel Magic, trademark
of Magic
American
Corp.,
or similar
product
using a clean,
soft cloth. Avoid harsh or gritty cleaners
or
scouring
pads which may scratch the finish.
Inside--The
inside of the dishwasher
is self-
cleaning
with normal
use. If needed,
clean around
the tub gasket
area
with a damp cloth.
The filter is self-
cleaning.
A glass
trap located
in the
center of the filter
is designed
to
collect
pieces of
broken glass,
straws,
bones and
pits. To remove
items in glass trap,
grasp
handle,
lift
out, empty
and replace.
Note:
Hard water may cause lime deposit
buildup
on the interior of the dishwasher.
For cleaning
instructions
see "Removing
Spots and Film"
section.
Overfill
Protector--keeps
dishwasher from
overfilling
and is located
in the left front corner of
the tub.
• Clean occasionally
with household
cleaner
containing
vinegar
or bleach to
dissolve
any buildup.
• Overfill
Protector
should
move up and down
freely about one inch. If
it does not move, lift
and clean
underneath.
15
Care of Drain Air Gap
If a drain air gap was installed for your built-in
dishwasher,
check to make sure it is clean so the
dishwasher
will drain properly.
A drain air gap is
usually
mounted
on countertop
and can be
inspected
by removing
the cover.
This is not part
of your dishwasher
and is not covered
by
warranty.
Property Damage Hazard
Freezing temperatures
may cause water lines
to rupture. Be sure all supply lines to and
circulating lines within dishwasher
are
protected.
Failure to do so could result in property
damage.
Winterizing
A dishwasher
left in an unheated
place should
be
protected
from freezing.
Have a qualified
person
do the following:
To Disconnect
Service:
1. Turn off electrical
power to the dishwasher
at
the supply
source by removing
fuses or
tripping
circuit
breaker.
2. Shut off water supply.
3. Place a pan under the inlet valve. Disconnect
water line from inlet valve and drain into pan.
4. Disconnect
drain line from pump and drain
water into pan.
Note: See Installation
Instructions
for more
details.
To Restore Service:
1. Reconnect the water, drain, and electrical
power supply.
2. Turn on water and electrical power supply.
3. Fill both detergent cups and run dishwasher
through a POTS PANS cycle.
4. Check connections to make sure they do not
leak.
Note: See Installation Instructions for more
details.