Corbin Russwin Access 800 Kurulum Talimatları Kılavuzu - Sayfa 7
Kilitler Corbin Russwin Access 800 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Corbin Russwin Access 800 17 sayfaları. Cl33800 tcac2 series cylindrical lockset
Ayrıca Corbin Russwin Access 800 için: Kurulum Talimatları Kılavuzu (16 sayfalar), Programlama Talimatı (16 sayfalar)
Sayfayı Yazdır
Installation of Outside Escutcheon
4
1. For exterior applications, an optional M99 Weatherseal Gasketing Kit can be ordered when a
device is ordered. this kit includes gaskets and a conduit. When ordering the kit separately,
order part number 794F929. The gaskets may be used as a seal between the escutcheon
and the door surfaces.
2A. For fire rated doors feed ribbon cable connector and ground wire from outside escutcheon
through the fire stop plate.
2B. For non-fire rated doors, feed ribbon cable connector and ground wire from outside escutcheon
through weather seal gasket (if used), then conduit sleeve in door (not shown).
3. With outside lever horizontal, insert mounting posts into the door. Make certain
the lever spindle is properly engaged in lock. (see diagram and Note A. below)
Screw cylinder into mortise lockbody make certain the cylinder orientation is in the correct
position (see diagram below) . Using the 7/64 Allen wrench provided, hand tighten (5-10 in. lbs.)
the cap screw to prevent unscrewing of the cylinder. Turn the key to make certain that the
locking mechanism (latch, deadbolt, key) functions correctly. Tighten (2) #12 x 1" lockbody
screws. Remove Allen wrench.
C A U T I O N
DOOR MUST REMAIN OPEN
DURING INSTALLATION.
USE DOOR STOP.
Spindles
Use Correct Spindle Orientation
STANDARD
Lever
Installation Instructions
Keypad ribbon cable
Ground
wire
MUSÉO
Lever
Outside
of Door
Gasket (optional)
GASKET APPLICATION:
Peel off the adhesive protective paper from
gasket. Feed Trim assembly motor harness
through gasket opening as shown and firmly
press gasket to escutcheon, aligning edge of
gasket with the edge of the escutcheon.
6
NOTE A.
For MUSÉO Lever
collections ONLY.
Rotate adapter
bushing as needed
to insure horizontal
lever position and
maximum thread
engaging lever -
adapter bushing.
NOTE: Key and
cylinder must be
rotated as shown
Correct
Incorrect