Jade GIGALINK GLR43302 Kurulum Talimatları - Sayfa 2
Alıcı Jade GIGALINK GLR43302 için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Jade GIGALINK GLR43302 2 sayfaları.
Sayfayı YazdırDifferent Modes for the Output
Modes are user selectable from the 2-way dipswitch. Dipswitch 1 corresponds to relay channel 1 and
dipswitch 2 corresponds to relay channel 2.
Momentary Mode If the dipswitch is "off" the relay will be in momentary mode.
Flipflop Mode
Latching Mode
Symptom
Receiver not responding to transmitter after
programming.
Transmitter activates wrong channel on a multi-
channel receiver.
Transmitter has short range.
Led is flashing on the transmitter.
JADE safety&security B.V.
Vlierlaan 5
3735 KT BOSCH EN DUIN
NEDERLAND
If the dipswitch is "on" the relay will be in flipflop mode.
If latching is required (Relay stays on until power is removed) the latching link
should be inserted and soldered into the two holes to the right of the 2-way
dipswitch. This will enable corresponding relays to latch.
Troubleshooting
This section contains helpful troubleshooting tips and solution.
T: 030-2250 500
F: 030-2250 514
I : www.jade-bv.nl
Solution
Try to program the transmitter again, but this
time connect battery to the transmitter.
If transmitter only programs when the battery is
connected, return transmitter to Elsema.
Check if GIGALINK™ cable is inserted
correctly
Wrong dip switch setting while programming
the receiver. Use the dip switch table and
program again
Check receiver antenna connection. If you are
using a shielded coax cable, check that the
shield and core are connected properly.
Replace battery.
ELSEMA
Enter the world of wireless
KvK: 16039021
Rabobank: 1217.11.757
BTW: NL0046.77.286.B.01
Leveringsvoorwaarden: zie website