HIKOKI WH 18DDX Taşıma Talimatları Kılavuzu - Sayfa 8

Matkap HIKOKI WH 18DDX için çevrimiçi göz atın veya pdf Taşıma Talimatları Kılavuzu indirin. HIKOKI WH 18DDX 17 sayfaları.

Sayfayı Yazdır

● Regarding the temperatures and charging time of the

battery.

The temperatures and charging time will become as

shown in Table 2.

Charger

Battery

Charging voltage

Weight

Temperatures at which the

battery can be recharged

Charging time for battery

capacity, approx. (At 20oC)

1.5 Ah

2.0 Ah

2.5 Ah

3.0 Ah

4.0 Ah

5.0 Ah

6.0 Ah

8.0 Ah

Number of battery cells

NOTE

The recharging time may vary according to temperature

and power source voltage.

CAUTION

When the battery charger has been continuously used,

the battery charger will be heated, thus constituting

the cause of the failures. Once the charging has been

completed, give 15 minutes rest until the next charging.

4. Disconnect the charger's power cord from the

receptacle.

5. Hold the charger ﬁ rmly and pull out the battery.

NOTE

Be sure to pull out the battery from the charger after use,

and then keep it.

Safeguard Function

Overburden Protection

Temperature Protection

Table 2

UC18YFSL

14.4 – 18

0.5

0oC – 50oC

min.

120

4 – 10

LED Light Display

On 0.1 second/oﬀ 0.5 second

On 0.3 second/oﬀ 0.3 second

CAUTION

○ If the battery is charged while it is heated because it has

been left for a long time in a location subject to direct

sunlight or because the battery has just been used, the

pilot lamp of the charger lights for 1 second, does not

light for 0.5 seconds (oﬀ for 0.5 seconds). In such a case,

ﬁ rst let the battery cool, then start charging.

○ When the pilot lamp ﬂ ickers (at 0.2-second intervals),

check for and take out any foreign objects in the charger's

battery connector. If there are no foreign objects, it is

probable that the battery or charger is malfunctioning.

Take it to your authorized Service Center.

○ Since the built-in micro computer takes about 3 seconds

to conﬁ rm that the battery being charged with charger

is taken out, wait for a minimum of 3 seconds before

reinserting it to continue charging. If the battery is

reinserted within 3 seconds, the battery may not be

properly charged.

MOUNTING AND OPERATION

Action

Removing and inserting the battery

Charging

Mounting the bit

Reversing the rotational direction

Switch operation

How to use the LED light

Mounting and removing the hook

(sold separately)

Selecting accessories

LED LIGHT WARNING SIGNALS

This product features functions that are designed to protect

the tool itself as well as the battery. While the switch is

pulled, if any of the safeguard functions are triggered

during operation, the LED light will blink as described in

Table 3. When any of the safeguard functions are triggered,

immediately remove your ﬁ nger from the switch and follow

the instructions described under corrective action.

Table 3

Remove the cause of the overburdening.

Allow the tool and battery to thoroughly cool.

Figure

―

Corrective Action

Page