Gree NEO12HP230V1A Kullanıcı El Kitabı - Sayfa 7

Klima Gree NEO12HP230V1A için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Gree NEO12HP230V1A 12 sayfaları. High-wall ductless air conditioning & heating system
Ayrıca Gree NEO12HP230V1A için: Hızlı Başlangıç Kılavuzu (2 sayfalar)

Gree NEO12HP230V1A Kullanıcı El Kitabı
TWD-0813-033 Neo Manual REV:Layout 1 9/27/13 11:14 AM Page 13
OPERATION OF WIRELESS REMOTE CONTROLLER
The wireless remote controller is the interface between the user and the neo system.
Commands are entered by the user to control the system. Any command that has been
entered with the remote controller will remain in memory until it is changed by the user
or the batteries are replaced.
When entering commands, point the remote controller in the direction of the LED display
on the front panel. The
indicator will appear for a short period of time on the remote
controller when the command is entered. The unit will emit an audible beep when the
signals are received correctly.
ON/OFF BUTTON
When the system is in OFF mode, the remote controller will
display the time and last room setpoint. When you press the
ON/OFF button, the unit will start in the last operating mode
and room setpoint.
NOTE: If the ON/OFF button is pressed too soon after a
stop, the compressor will not start for 3 minutes due to the
inherent protection against frequent compressor cycling.
PRIVACY LOCK MODE
The Privacy Lock prevents unauthorized access to the unit
controls and prevents tampering with system settings. The
remote controller can be locked by pushing the "+" and "-"
buttons simultaneously for 2 seconds. The Privacy Lock icon
will be displayed on the remote controller. Repeat the
process to unlock the remote controller.
OPERATION OF WIRELESS REMOTE CONTROLLER
MODE BUTTON
Use the "MODE" button to select one of the available modes.
The selected mode will be displayed on the remote controller
and the appropriate light will illuminate on the display panel.
AUTO – Unit will automatically select heating or cooling to
maintain room temperature between 68°F and 77°F.
The remote controller will display the Auto Mode icon with
no setpoint. The front panel display will show "77. "
COOL – To cool to selected setpoint and remove moisture.
System varies compressor speed to maintain desired temperature.
HEAT – To heat to selected room setpoint. System varies compressor speed to maintain
desired room temperature.
FAN ONLY – To circulate air without heating or cooling. Use Fan Speed button to select
speed from low to high.
DRY – Select DRY MODE to increase moisture removal during warm humid conditions.
ON Mode Display
1. Room Temperature > Setpoint +4°F, the system will be operating in cooling
2. Setpoint -4°F, < Room Temperature < Setpoint +4°F, the system will cycle
3. Room Temperature < Setpoint -4°F, the system will be OFF and the indoor fan
Privacy Lock Display
11
mode with low fan speed.
6 minutes ON and 4 minutes OFF in cooling mode. The indoor fan will be at
low speed.
will be at low speed.
: AUTO
: COOL
: DRY
: FAN ONLY
: HEAT
Icons Displayed
12