AGT INDUSTRIAL AGT-ST4040C Ürün Kılavuzu - Sayfa 9

Endüstriyel Ekipmanlar AGT INDUSTRIAL AGT-ST4040C için çevrimiçi göz atın veya pdf Ürün Kılavuzu indirin. AGT INDUSTRIAL AGT-ST4040C 10 sayfaları. 40ft x 40ft container roof shelter

Sayfayı Yazdır

As shown on (figure 6), when you are ready to install the roof cover (#20),



unpack the cover and position it parallel to the building frame on one side.

The cover must be pulled over the top of the truss frame without being



snagged or stressed on any frame members.

Use multiple ropes over the top of the frame. Having a couple of people inside



of the structure with a ladder to assist to push upwards would help the cover to

be pulled over smoothly without any damage.

Step 6 : Tension the cover on the frame from side to side (figure 7)

After the cover is installed on the roof, insert the plastic pipe (#18) use Connect



with (#19) slowly into the grooves on two ends of the cover (not two sides).

Insert tension tubes (#7) slowly into the bottom groove pocket on both long



sides. Add the water plug (#17) on the first tension tube to avoid tearing the

fabric and add one to the end of last tube as well.

Stretch and adjust the cover from left and right, back and forth, to make sure it



is square and centered. Cut the groove pocket where it aligns with ratchet (#10)

and use tie down straps (#13) to pull tension tube (#7) toward the ratchet and

tie it firmly there.

Parts used in this step.



- (2 groups) Top cover tension tube (#7)

- (38) Ratchets (#10)

Figure 6