GAME NS6028 Kullanıcı El Kitabı - Sayfa 4

Yüzme Havuzu Isıtıcısı GAME NS6028 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. GAME NS6028 13 sayfaları. Curve heater

GAME NS6028 Kullanıcı El Kitabı
1.

SAFETY WARNINGS

READ ALL WARNINGS BELOW. FAILURE TO DO SO COULD RESULT IN SERIOUS PERSONAL INJURY OR DEATH.
Carefully read and adhere to all CAUTION and NOTE notices located throughout this manual.
Failure to comply with these instructions can cause serious injury, death, or damage to the unit.
Do NOT allow children to operate this product.
Always turn the filter system to a setting that does not allow flow to the pool return when installing
or working on the solar heater.
Install product away from the pool to prevent children from using the heater as a way to access the pool.
NEVER service this unit with the pool pump running.
Do not use any petroleum based lubricant. Petroleum based products will destroy plastic parts.
THESE CAUTION WARNINGS ARE NOT INTENDED TO INCORPORATE ALL POSSIBLE INSTANCES FOR RISK AND/OR SEVERE
INJURY. THE POOL OWNER SHOULD ALWAYS EXERCISE CAUTION AND COMMON SENSE WHEN UTILIZING THEIR SWIMMING
POOL AND OPERATING EQUIPMENT.
2.

GENERAL INFORMATION

This manual provides information relating to the installation, utilization and maintenance of our solar heater. We recommend you read
this manual in its entirety and keep it for future reference.
The solar heater you just purchased for your above ground pool is simple to install and effortless to operate once connected. The
installation instructions included in this manual are based on a few assumptions: 1) you have an existing above ground pool that is
completely set up and filled with water, 2) your above ground pool is equipped with a pump-operated water filtering system, and 3)
you have the necessary hoses needed to feed water in and out of your pool and filter system.
These assumptions are necessary as the solar heater, once installed, will be completely dependent upon your pool's filter pump to push
water in and through the heater's solar coils.
How It Works
When properly installed, the solar heater will be connected to your filter and your pool by two hose connections: One hose will feed
cold, filtered pool water from your pump into one port of the solar heater. The other hose will feed sun warmed water from the other
port of the solar heater to your pool via the pool return inlet in your pool. As cold water is fed into the solar heater, it travels through
the solar coils where it is heated by the sun before it is delivered back into your swimming pool.
Unpacking Your Solar Heater
Carefully remove the product and all component parts from the box. Make certain all parts are present before beginning assembly
(see Section 2, Parts List/Reference).
Tools & Equipment Required
The following items are not included with your new solar heater, but will be required for proper installation and operation:
#2 Phillips screwdriver
¼" Flat head screwdriver
Silicone based lubricant
Know Your Pool
Before you begin installation it is a good idea to know certain specifications about your pool:
How big is your pool?
How many gallons does it hold?
What size hose does it use? (i.e. 1¼" dia, 1½" dia or 2¼" dia)
What kind of hose connection does your pool use? (i.e. threaded/unthreaded)
What location will position the heater for maximum sun exposure?
SAVE THESE INSTRUCTIONS
4