GAME SolarPRO XB2 Kullanıcı El Kitabı - Sayfa 8

Yüzme Havuzu Isıtıcısı GAME SolarPRO XB2 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. GAME SolarPRO XB2 12 sayfaları.

TROUBLESHOOTING

Problem

Does not appear to be heating

the pool

No initial bubbling after heater is

connected and pump is on

Bubbles continue to flow out of the

pool water inlet well after the pump

has been turned on

Dripping or leaking from connectors

High pump pressure

SAVE THESE INSTRUCTIONS

Possibilities/Solutions

• C heck to make sure that water is flowing through the water channels. Check the flow

strength at the pool inlet

• H as it been sunny?

• P ut your pool cover on at night to prevent heat loss.

• A dditional heaters and bypass kit may be necessary.

• C heck the setting of the filter to make sure it is returning water to the pool through the

pool water inlet

• C heck flow rate.

• C heck the connections for a suction leak.

• C heck to make sure the flow rate is normal.

• T here could be a break in the tubing.

• T here could be a clog in the tubing, try to purge out

the clog

• C heck the connector seals and o-rings and replace or repair if defective.

• I f the heater is punctured, use the included repair kit, or a kit made for PVC pool or

waterbed repair, to patch the puncture

• Tighten the elbow connectors by hand.

• Coat all seals and o-rings with a thin layer of gasket lubricant, available at your local

hardware or pool store

• F low through heater may be too high. A bypass kit may be needed.

• F ilter may need to be replaced, cleaned or backwashed.