Airetool EIC-625-1000 Kullanım ve Servis Kılavuzu - Sayfa 13
Elektrikli Alet Airetool EIC-625-1000 için çevrimiçi göz atın veya pdf Kullanım ve Servis Kılavuzu indirin. Airetool EIC-625-1000 16 sayfaları. Tube cutters
Sayfayı YazdırPOINTS FOR GOOD TUBE CUTTING
1. KEEP BITS COOL -
This will extend the bits life. It possible, use a flushing system of air and some type of good
cutting fluid.
2. DO NOT FORCE FEED -
To much pressure of the tool bits can cause the bits to puncture thru the tube wall which
may cause the bits to break.
3. KEEP BIT AND MANDREL AREA CLEAN OF CHIPS -
Cleaning of the chips from the area of the tool bits
and mandrel will allow for free movement of both. Chips in this area can cause the mandrel and or tool bits to bind and break.
4. SHARPEN TOOL BITS -
Sharpen tool bits, per above specifications, before they are allowed to wear and overheat.
Overheating will remove the temper from the tool bit so that sharpening will not last very long. KEEP BITS COOL !
5. TOOL BIT SELECTION -
Feed angels of the tool bit are very important for the type of material that is being cut. Be
sure that you are using the proper tool bits!
6. PROPER CUTTING SPEED -
This is very important for proper cutting and for tool bit life. See R.P.M. recommenda-
tions on page 18 in this manual.
Page - 13