Core GasLess CGT 400 Servis Kılavuzu - Sayfa 10

Düzeltici Core GasLess CGT 400 için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Core GasLess CGT 400 13 sayfaları.

HARDWARE AND PARTS REQUIRED:

‐RIGHT SIDE OF RH GRIP "B"

‐(2) SHAFT CLAMPS

‐(2) 10‐32 5/16 NUT

‐(1) 10‐32 ¾ BOLT

‐(1) 10‐32 5/8 BOLT

‐(4) RIGHT HAND GRIP SCREW

‐TRIGGER

‐TRIGGER SPRING

TOOLS:

‐(2) ELECTRIC/SCREW GUN, T25 AND T18 BITS

1. Place the 5/8" bolt through the shaft clamp hole on the

rear of handle, and the ¾" bolt through the shaft clamp

on the front part of the handle. Using the T25 bit, tighten

the shaft clamps so the grip handle is snug to the shaft.

2. Place the lockout lever on the post as shown in picture 2,

with the spring pre‐loaded.

3. Place the Trigger down on it's post with the spring

preloaded, as shown in picture 3.

4. Route wire back to Power Housing and plug wire

connector back into Controller.

Power Housing / Grip Handle Assembly