HIKOKI WW10A Taşıma Talimatları Kılavuzu - Sayfa 6

Darbeli Sürücü HIKOKI WW10A için çevrimiçi göz atın veya pdf Taşıma Talimatları Kılavuzu indirin. HIKOKI WW10A 12 sayfaları.

Workplace hazards

- Slips, trips and falls are major causes of workplace injury. Be aware of slippery surfaces

caused by the use of the tool and also of trip hazards caused by the air line or hydraulic

hose.

- Proceed with care in unfamiliar surr oundings. Hidden hazards, such as electricity or other

utility lines, can exist.

- The power tool is not intended for use in potentially explosive atmospheres and is not

insulated against coming into contact with electric power.

- Make sure there are no el ectrical cables, gas pipes, etc., that can cause a hazard if

damaged by use of the tool.

Dust and fume hazards

- Dust and fumes generated when using power tools can cause ill health (for example,

cancer, birth defects, asthma and/or dermatitis); risk assessment and implementation of

appropriate controls for these hazards are essential.

- Risk assessment should include dust created by the use of the tool and the potential for

disturbing existing dust.

- Operate and maintain the tool as recommended in these instructions, to minimize dust

and fume emissions.

- Direct the exhaust so as to min imize disturbance of dust in a dust -filled environment.

- Where dust or fumes are created, the priority shall be to control them at the point of

emission.

- All integral features or accessories for the collection, extraction or suppression of airborne

dust or fumes should be correctly used and maintained in accordance with the

manufacturer's instructions.

- Select, maintain and replace the consumable/inserted tool as recommended in the

instruction handbook to prevent an unnecessary increase in dust or fumes .

- Use respiratory protection in accordance with employer's instructions and as required by

occupational health and safety regulations.

Noise hazards

- Exposure to high noise levels can cause permanent, disabling, hearing loss and other

problems, such as tinnitus (ringing, buzzing, whistling or humming in the ears). Therefore,

risk assessment and implementation of appropriate control s for these hazards are

essential.

- Appropriate controls to reduce the risk may include actions such as damping materials to

prevent workpieces from "ringing".

- Use hearing protection in accordance with employer's instructions and as required by

occupational health and safety regulations.

- Operate and maintain the power tool as recommended in the instruction handbook, to

prevent an unnecessary increase in noise levels.

- Select, maintain and replace the consumable/inserted tool as recommended in the

VII Page 6 of 15