Adeunis RF SIGFOX-EUROPE Kullanıcı Kılavuzu - Sayfa 6

Verici Adeunis RF SIGFOX-EUROPE için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Adeunis RF SIGFOX-EUROPE 9 sayfaları. Demonstrator

ADEUNIS RF - SIGFOX EUROPE demonstrator - USER GUIDE V1.1

4. Switching the product on

When you switch the ON/OFF button towards the right, the product is switched on and starts in nominal mode.

OFF Position

4.1.

•

On power-up, LED 2 lights up with a continuous red light for a maximum of 8 minutes. This phase corresponds to the GPS's ini-

tialisation/synchronisation phase. The length of this phase is dynamic: if the GPS synchronises before the period of 8 minutes has

elapsed, LED2 will become orange and the initialisation phase will end 50 seconds later. During the GPS's initialisation phase, no

action is possible (no transmission of RF frames).

•

Once this initialisation phase has been completed, the product enters the nominal operating cycle. This cycle is composed of 5

stages.

1 – LED 1 green with rapid flashing (2 times), LED 2 continuous

red after 3 seconds.

2 – LED 1 flashing red 3 times

3 – LED 1 continuous green while waiting and during reception

4 – LED 1 flashes red once

5 – LED 1 flashes green 5 times and rapidly

The cycle is repeated periodically, every 10 minutes.

A diagram is given in APPENDIX 2 with a visual description of the nominal cycle.

There are two ways of triggering frame transmission manually. Frames can only be sent between two cycles of nominal operation.

When a nominal operating cycle is being executed, users can do nothing.

Pressing BP1 triggers the execution of a nominal cycle, and the transmission of SIGFOX frames.

The remote control includes an accelerometer. If it is shaken, it triggers the execution of a nominal cycle, and therefore transmission of

SIGFOX frames.

Stage

ON Position

Meaning

Wake up of the GPS pending synchronisation

When GPS is synchronised, LED 2 switches to continuous

orange.

If the GPS is not synchronised, the LED remains on continuous

red.

A SIGFOX message is being sent, with 2 repeats

Reception window, waiting for a response from the SIGFOX

server

The response has been received. The OOB frame is sent

The cycle finished correctly. The response received from the

server is output on the Demonstrator's serial link.

Page

of 9