HIKVISION ColorVu DS-2CE72KF3T-E Kullanıcı Kılavuzu - Sayfa 4
Güvenlik Kamerası HIKVISION ColorVu DS-2CE72KF3T-E için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. HIKVISION ColorVu DS-2CE72KF3T-E 19 sayfaları. Bullet & turret camera
Sayfayı Yazdır
Safety Instruction
These instructions are intended to ensure that user can
use the product correctly to avoid danger or property
loss.
The precaution measure is divided into "Warnings" and
"Cautions".
Warnings: Serious injury or death may occur if any of the
warnings are neglected.
Cautions: Injury or equipment damage may occur if any of
the cautions are neglected.
Warnings Follow
these safeguards to
prevent serious injury
or death.
Warnings
In the use of the product, you must be in strict
compliance with the electrical safety regulations of the
nation and region.
Input voltage should meet both the SELV (Safety Extra
Low Voltage) and the Limited Power Source with 12
VDC according to the IEC60950-1 and IEC62368-1
standard. Refer to technical specifications for detailed
information.
The socket-outlet shall be installed near the equipment
and shall be easily accessible.
An all-pole mains switch shall be incorporated in the
electrical installation of the building.
Do not connect multiple devices to one power adapter
to avoid over-heating or a fire hazard caused by
overload.
Make sure that the plug is firmly connected to the
power socket.
If smoke, odor or noise rise from the device, turn off
the power at once and unplug the power cord, and
then contact the service center.
Never attempt to disassemble the camera by
unprofessional personal.
Cautions
CAUTION: Hot parts! Burned fingers when handling the
parts. Wait one-half hour after switching off before
For device with this sticker, this device is intended for
installation in a restricted access location, access can
only be gained by service persons or by users who have
been instructed about the reasons for the restrictions
applied to the location and about any precautions that
shall be taken.
The equipment shall not be exposed to dripping or
splashing and that no objects filled with liquids, such as
vases, shall be placed on the equipment.
Shock hazard! Disconnect all power sources before
maintenance.
handling parts. This sticker is to indicate
that the marked item can be hot and
should not be touched without taking care.
Cautions Follow these
precautions to prevent
potential injury or
material damage.