deante ADR 0821 Hızlı Başlangıç Kılavuzu - Sayfa 6
İç Mekan Mobilyaları deante ADR 0821 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. deante ADR 0821 16 sayfaları.
Sayfayı Yazdır
The LEDS are powered from 5000mAh battery built into
the mirror that can be charged by USB cable type C con-
nected to the power source (e.g. charger, powerbank).
USB C
The assembly kit includes 2 mounting plates with di-
mensions of 10x5 cm and 30x5 cm. They can be instal-
led in two different rooms and in any position.
The longer plate mounted vertically gives us the pos-
sibility to adjust the mirror height, which makes the
product easy to use for people of different heights. The
horizontal placement of the plate, on the other hand, will
allow the user to move the mirror sideways.
Assembly is tool-free, using a mirror-finished tile and
strong 3M double-sided adhesive tape.
Detailed assembly and care instructions are provided in
the further part of this leaflet.
Precautions
1.
Do not put the product in places of high temperature.
2. It is recommended not to fully discharge the device.
3. Use clean water and mirror cleaning detergents for
cleaning.
4. Turn off and remove from the mounting plate for cle-
aning. Use a soft absorbent cloth to avoid scratches
or leaving fibres on the mirror surface. Do not press
the mirror when cleaning.
5. Do not pour or spray the cleaning agents directly
onto the mirror.
6. Do not immerse the product in water or other liquids
while cleaning or operating.
7.
Protect against ingress of water and other liquids
inside the device.
8. Protect against loose products from getting inside
the device.
9. Do not use electrical appliances while bathing or
showering.
10. Do not touch the electrical product if it has fallen
into water or has been flooded.
11. Do not touch the device with wet hands.
6
12. The product is not a toy. Make sure children are un-
der adult supervision when using the mirror.
13. Keep out of reach of children.
14. Mounting the mirror to the previously glued plate
must be slow and gentle due to the strong magnet
mounted in its housing. This is especially important
4-6
when installing a tile on the mirror, as it may break
tyg/weeks
due to an impact.
15. Do not look at the light source with any optical in-
struments which focus the light rays.
16. The product should never be exposed to direct ac-
tion of heat sources such as: excessive sunlight, he-
ater, fire. There is an increased risk of fire in direct
sunlight.
17. The product must not be disassembled or thrown
into fire.
18. There are no user-serviceable parts in this equip-
ment.
19. Under no circumstances should you open or repa-
ir the device yourself, as this may impair its proper
operation. Failure to comply with the above rules
voids the warranty.
20. Check the cable, plug, housing and other parts re-
gularly for damage. If damage is found, the product
must not be used with a charger.
User manual
1. Before the first use, charge the battery with the inc-
luded USB type C charger cable.
2. The first charging should take up to 8 hours. Any sub-
sequent charging - up to 6 hours.
3. Battery charging should occur outside the wet area of
the bathroom, i.e. outside all surfaces directly exposed
to water, e.g. near the bathtub, washbasin, shower, etc.
4. Disconnect the mirror from the power supply after
the battery charging is complete.
5. To turn on the LED lighting, touch the mirror surface
in any place or make a quick gesture with your full
hand right in front of the mirror in the forward-bac-
kward direction.
6. Another touch of the mirror or the gesture of bringing
the hand closer (front-back) changes the color of the
light from white to yellow.
7. Another touch or the gesture of bringing the hand
closer (front-back) turns off the lighting.