DeatschWerks 4-VB40aX1 Kurulum Kılavuzu - Sayfa 7

Genişletici DeatschWerks 4-VB40aX1 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. DeatschWerks 4-VB40aX1 8 sayfaları. Single and dual fuel pump voltage booster

Sayfayı Yazdır

4 – Click the roller wheel to access the menu. If there is a lock set you will be shown the lock screen, enter the

lock code if you have it. The default lock code is "4849" if it is present on a new booster. This will move you to

the Status menu, this shows the current settings and the current voltage being output by the VB40a.

5 – Select the Settings menu to adjust the default settings of the VB40a.

Mode:

Active Low = Grounding the white control wire to enable the boosted voltage selected.

Always On = Constant 18v output, control wire does nothing.

Ramp:

Auto = This automatically picks the ramp rate depending on the voltage selected.

1.5s = 1.5 seconds from 14.5v to the voltage selected.

1s = 1 second from 14.5v to the voltage selected.

0.5s = 0.5 seconds from 14.5v to the voltage selected.

Instant = No delay from 14.5v to the selected voltage (can cause spikes if used over 18v)

Voltage:

14.5v (This is the base voltage, when not activated the booster always outputs 14.5v)

18v = When activated the booster will output 18v

20v = When activated the booster will output 20v

22v = When activated the booster will output 22v

26v = When activated the booster will output 26v (Only available in Brushless Type)

Type:

Brushed = Used with standard brushed DC motors

Brushless = Use with brushless controllers and pumps, unlocks 26v setting.

Lock:

Disable or Enable = Use the default lock code "4849" to enable or disable the lock.

DeatschWerks

VB40a 40amp Voltage Booster Installation Guide