Gree HLR8Pd/Na-K Ünite Kurulum Kılavuzu - Sayfa 3
Soğutucu Gree HLR8Pd/Na-K için çevrimiçi göz atın veya pdf Ünite Kurulum Kılavuzu indirin. Gree HLR8Pd/Na-K 18 sayfaları. Mini chiller
Sayfayı Yazdır
1.Installation Guides
WARNING!
Installation should be performed by GREE appointed servicemen, or improper installation would lead to
①
unusual operation, water leakage, electric shock or fire hazard.
The unit should be installed on the foundation which is capable of supporting the unit, or the unit would fall
②
off or even lead to personal injury.
All electric installation should be done by electrician in accordance with local laws and regulations, as
③
well as the User's Manual and this Service Manual. Besides, the special power lines should be used, as any
improper line would lead to electric shock or fire hazard.
All electric lines should be safe and secured reliably. Be sure the terminal board and electric lines will not
④
be affected by any external force, or it would lead to fire hazard.
The electric lines should run properly to make the cover of the electric box secured tightly, or it would
⑤
cause the terminal board overheated or cause electric shock or fire hazard.
Cut off the power supply before touching any electric element.
⑥
CAUTION!
The unit should be grounded properly and the ground line is not allowed to connect with the gas line,
①
water line, lightning rod or phone line.
The breaker should be installed, or it would lead to electric shock.
②
The drain pipe should be installed in accordance with the User's Manual and this Service Manual to
③
ensure free drainage, and the drain pipe should be insulated against condensation. Once the drain pipe is
installed improperly, it would lead to water leak which then will damps the ceiling and furniture.
Do not place the unit where there is oil fog, like kitchen, or the plastic would be aged, broken off or the
④
polluted evaporator would lead to water leak and poor performance.
Do not place the unit where there is corrosive gas (like sulfur dioxide), or the corroded copper tubes or
⑤
welded joint would lead to refrigerant leakage.
Do not place the unit where there is inflammable gas, carbon fiber, inflammable dust or volatile
⑥
combustible, as they would lead to fire hazard.
SAFETY!
Always use safety outfits at the construction site.
①
No smoking and no drunken operation are allowed at the construction site.
②
Wear no gloves and tighten the cuff when operating the machinery and electrical equipment. Do not
③
maintain it during operation.
Use the abrasive-disk cutter and stand at the side of the rotating abrasive disk.
④
Clean the opening when installing the riser pipe, and then cover it tightly. Do not throw down any material.
⑤
The use of the electric and gas welders should be approved firstly. Once used, a fire distinguisher should
⑥
be prepared and a service man should be there always. There should be no inflammable and explosive
substances around the welding site.
A platform should be set up when working high above the ground.
⑦
1.1 Installation Positions of the Mini Chiller
(1). Avoid direct sunshine.
(2). Monobloc unit must be installed on a firm and solid support.
(3). Ensure the hanger rod, ceiling and building structure have sufficient strength to support the weight of air
conditioner unit.
(4). Avoid placing the monobloc unit under window or between two constructions, hence to prevent normal
operating noise from entering the room.
(5). Air flow at inlet and outlet shall not be blocked.
(6). Install at a well-ventilated place, so that the machine can absorb and discharge sufficient air.
(7). Do not install at a place where flammable or explosive goods exist or a place subject to severe dust,
1
Unit Installation