deBont Vidur Kullanıcı El Kitabı - Sayfa 3

Amplifikatör deBont Vidur için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. deBont Vidur 10 sayfaları.

█ FX loop section

Instead of connecting your effects between your bass and the Vidur's input, you can use the

available FX loop. This has many technical advantages and makes for a clean setup. The

Vidur is equipped with a fully parallel, mixable FX loop. By mixing clean bass with the signal

that has been moulded by your chain of effects, the tonal possibilities become even greater.

Another big plus of mixing in a bit of clean signal, is the retention of a solid, full, rich bass

sound, which some effects pedals, unfortunately, seem to lack.

mix : The mix control determines the balance

between your clean signal (dry) and the signal being

returned from the FX loop (wet). Turning the control

fully counterclockwise results is a 100% dry signal,

as if the FX loop was completely disabled. Turning

fully clockwise will only give the (wet) effects signal

coming in from the FX return connector (see 'back'

section below). Anything in between is a mix of the

wet and dry signal.

level : The level control sets the overall volume being fed back to the the preamp from the FX

loop. This is especially useful when regularly switching between the clean- and effects

signal. The level control will then act as the balance between the two states.

Note: The FX loop can be used as an auxiliary input/output as well, for e.g. practicing

purposes. The audio source (laptop, MP3 player, etc) can be connected to the FX return and

mixed in to the desired level with the mix and level controls.

The FX button enables or disables the FX loop section. When disabled, the FX loop is

removed completely from the audio path by means of a true bypass. This button is also

available on the optional footswitch.

● red:

FX loop disabled

● green: FX loop enabled

deBont Amps Vidur Tube Preamplifier Owner's Manual