CentralPneumatic 62541 Kullanıcı El Kitabı - Sayfa 4
Testere CentralPneumatic 62541 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. CentralPneumatic 62541 16 sayfaları. High speed metal saw
Sayfayı Yazdırtool use and care
1� Use clamps or another practical way
to secure and support the workpiece
to a stable platform. Holding the work
by hand or against the body is unstable
and is able to lead to loss of control�
2� Do not exceed the maximum
16 gauge thickness when cutting
sheet metal with Saw.
3� Do not force the tool. Use the correct
tool for the application� The correct tool
will do the job better and safer at the
rate for which the tool is designed�
4� Do not use the tool if the switch does
not turn the tool on or off. Any tool
that cannot be controlled with the switch
is dangerous and must be repaired�
5� Disconnect the tool from the air source
before making any adjustments, changing
accessories, or storing the tool. Such
preventive safety measures reduce the risk
of starting the tool unintentionally� Turn off
and detach the air supply, safely discharge
any residual air pressure, and release
the throttle and/or turn the switch to its off
position before leaving the work area�
Service
1� Tool service must be performed only
by qualified repair personnel.
2� When servicing a tool, use only
identical replacement parts. use
only authorized parts.
air Source
1�
never connect to an air source
that is capable of exceeding
200 psi. Over pressurizing the
tool may cause bursting,
abnormal operation, breakage of the tool or
serious injury to persons� Use only clean,
dry, regulated compressed air at the rated
pressure or within the rated pressure range
as marked on the tool� Always verify prior to
SaVe tHeSe inStructiOnS.
Page 4
For technical questions, please call 1-888-866-5797.
6� Store the tool when it is idle out of
reach of children and other untrained
persons. A tool is dangerous in
the hands of untrained users�
7� Maintain the tool with care. Keep a cutting
tool sharp and clean� A properly maintained
tool, with sharp cutting edges reduces the
risk of binding and is easier to control�
8� check for misalignment or binding
of moving parts, breakage of parts,
and any other condition that affects
the tool's operation. If damaged,
have the tool serviced before using�
Many accidents are caused by poorly
maintained tools� There is a risk of
bursting if the tool is damaged�
9� use only accessories that are identified
by the manufacturer for the specific
tool model. Use of an accessory not
intended for use with the specific tool model,
increases the risk of injury to persons�
3� use only the lubricants supplied with the
tool or specified by the manufacturer.
using the tool that the air source has been
adjusted to the rated air pressure or within
the rated air-pressure range�
2� Never use oxygen, carbon dioxide,
combustible gases or any bottled
gas as an air source for the tool.
Such gases are capable of explosion
and serious injury to persons�
Item 62541