Majestic MARQ42IN Kurulum Talimatları Kılavuzu - Sayfa 4
Kapalı Şömine Majestic MARQ42IN için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Majestic MARQ42IN 7 sayfaları. Ember lighting & refractory upgrade kit
Ayrıca Majestic MARQ42IN için: Cam Refrakter Montaj Talimatları (5 sayfalar)
Sayfayı Yazdır14. Once the plug for the LED Tub Assembly is disconnect-
ed, you can remove it from the appliance. Locate the
new LED Assembly from the upgrade kit. The new LED
Assembly will plug into the two connections located in the
appliance. See Figure 14.
PLUG-IN
CONNECTORS
NEW TUB ASSEMBLY
Figure 14 New LED Tub Assembly with connectors
Figure 15 New LED tub assembly installed in appliance
15. Replace the Glass Assembly that was previously re-
moved and fasten it to the firebox with the screws previ-
ously removed. Refasten all screws except for the back
middle one. Save screw for future step.
16. Locate the rear light cover. See Figure 16.
Figure 16 Rear Light Cover
4
Majestic • Upgrade Kit Installation Instructions • 2614-930 Rev. D • 3/19
17. Lay the rear light cover down on the inner glass assem-
bly underneath the light cover. See Figure 17.
REAR LIGHT COVER
INNER
GLASS
ASSEMBLY
LIGHT COVER
Figure 17 Installing Rear Light Cover
18. The rear light cover should slide between the inner glass
assembly and the light cover so that the clearance hole
of the rear light cover lines up with the hole of the in-
ner glass assembly. This is was left open in Step 15 (#2
screw shown in Figure 11). You may lift up on the light
cover so that the rear light cover can fully slide into posi-
tion underneath it.
19. Reinstall #2 screw saved in Step 15 (shown in Figure
11). This screw will hold down the rear light cover and
the inner glass assembly down to the firebox bottom.
See Figure 18.
Figure 18 Reinstall Center Back Screw
20. Reinstall the Burner / Grate Assembly by sliding the
burner tube fully onto the orifice on the back wall inside
the firebox. Line up the two front holes of the front grate
legs with the two existing screw holes in the bottom in-
side the firebox. See Figures 19 and 20.
SCREW