Adexa HZB-15/SA Kullanım Kılavuzu - Sayfa 8

Buz Yapıcı Adexa HZB-15/SA için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Adexa HZB-15/SA 9 sayfaları. Portable automatic ice maker

Sayfayı Yazdır

USING YOUR ICE MAKER

1. Open the cover, remove the ice basket and pour water into tank.
Keep water level below the water level mark.
2. Press "Power" button on the control panel to begin the ice making cycle.
3. Select the size of the ice cube by pressing the "Select" button. If the room temperature is
lower than 15℃, it is recommended to select the small or medium ice sign button in order to
avoid ice sticking together.
4. The ice making cycle lasts approx. 6 to 13 minutes, depending on the size of the ice cube
selection and the ambient temperature. In the extreme hot room temperature, ice-making
time maybe vary a lot.
5. While the icemaker is on, verify water level periodically. If water pump can't inject water, the
ice maker will stop automatically, and the "Add Water" indicator will be on.
Press "Power" button, fill water up to the max. water level mark and press "Power" button
again to turn on the unit again.
Allow the refrigerant liquid inside the compressor at least 3 minutes to settle before
restarting.
6. The ice maker automatically stops working when the ice basket is full and the "Ice" indicator
will be on.
7. Change water in the water reservoir every 24 hours to ensure a reasonable hygiene level.
If unit isn't in use, drain all water left in the tank.

TROUBLESHOOTING

PROBLEM
" Add Water" indicator is
on.
"Ice" indicator is on.
Ice cubes stick together.
Ice making cycle is normal
but no ice is made.
POSSIBLE CAUSE
Lack of Water.
There is too much ice.
The ice cycle is too long.
Water temperature in inner
tank is too low.
Ambient
temperature
water temperature in inner
tank is too high.
Refrigerant
in
system leaks.
Pipe in the cooling system
is blocked.
7
SOLUTION
Stop the ice maker, fill water, and
press "Power" button again to
restart the unit.
Remove ice from ice basket.
Stop the ice maker, and restart it
when the ice blocks melt. Select
the small size ice cube selection.
Change the water in the inner
Tank. Temperature of water is
better set between 8-32℃
or
Please run the ice maker below
32 ℃ and pour colder water into
tank.
cooling
Verify by a qualified technician.
Verify by a qualified technician.