Decagon Devices EM50R Hızlı Başlangıç Kılavuzu

Veri Kaydediciler Decagon Devices EM50R için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Decagon Devices EM50R 2 sayfaları.

Em50/Em50R/Em50 Solar

Introduction

Thank you for purchasing an Em50 series data logger. This data collection device

allows you to collect and store data from up to five sensors. The stored data can be

downloaded using the included USB cable or via radio to a base station (in case of

the Em50R). It is con-figured using either DataTrac

Packing List

Please check to make sure all listed items are present. If any item is missing or

damaged, please contact Decagon or your local distributor.

•

Em50 series data logger (Em50 or Em50R)

•

USB cable

•

Packet with 5 zip-ties and 5 AA alkaline batteries

•

Antenna (Em50R)

•

USB flashdrive with Software, driver and manual.

Note: The DataTrac3 or ECH2O Utility software and driver is required for

communication with the Em50 series data loggers. The software and driver must be installed

before using the Em50 (see the manual for software and driver installation instructions).

Turning on and Configuring the Em50

1. Install the 5 AA Alkaline batteries (included with shipment).

Note: Em50 Solar logger comes with batteries preinstalled. Remove battery pull-tab to

activate batteries. Use only NiMH (Nickel-Metal Hydride batteries with the Em50

Solar logger.

2. Press the silver reset button located above the batteries.

3. Connect the USB cable from your computer's USB port to the Em50's

COMM port.

4. Launch DataTrac 3, ECH2O Utility or ECH2O Utility Mobile software.

5. Select "Direct on COM..." from the "Connect via" dropdown menu.

6. Click on the Connect icon.

7. On the main menu, name the Em50 using a maximum of 8 characters (op-

tional).

8. Select the sensors you will be using in each port, as well as a measurement

interval.

9. If using a radio-enabled Em50R, set the Radio Channel (0 through

and Radio Subchannel (0 through 65534) to correspond with the

DataStation or Rm1 to which you will be broadcasting.

Quick Start Guide

,or ECH

O software

