decakila KUCF007W Manuel - Sayfa 6

Kahve Makinesi decakila KUCF007W için çevrimiçi göz atın veya pdf Manuel indirin. decakila KUCF007W 10 sayfaları.

Sayfayı Yazdır

7. After desired coffee has obtained, you should turn steam

knob to

position, the indicator go out and the coffee

maker stops working, your coffee is ready now. Then remove

the carafe and turn the steam control knob to

release the residual steam in the tank.

Warning: Do not leave the coffee maker unattended

during making the coffee, as you need operate manually

sometimes!

8. Before removing steel mesh or opening the tank cover, make

sure the pressure in the tank shall be released. The method

is turn the steam knob to the

the tank will eject from the frothing device. After pressure has

released, and wait for the steel mesh cooling down, you can

remove the steel mesh or open the tank cover.

9. After finishing making the coffee, you can take the funnel out

through turn clockwise, and then pour the coffee residue out

with the steel mesh pressed by press bar. Let them cool down

completely, then rinse under running water. (When assemble

the steel mesh again, you shall turn over the press bar to the

original position)

FROTHING MILK/ MAKE CAPPUCCINO

You get a cup of cappuccino when you top up a cup of espresso

with frothing milk.

position

position firstly, the steam in

Method:

1. Prepare espresso first with container big enough according

to the part "make espresso coffee".

2. Fill a jug with desired amount of milk for each cappuccino

to be prepared, you are recommended to use whole milk at

refrigerator temperature (not hot!).

Note: In choosing the size of jug, it is recommend the

diameter is not less than 70±5mm, and bear in mind that

the milk increases in volume, make sure the height of jug is

enough.

3. Turn the steam knob to the

light up.

4. Insert the frothing device into the milk about two

centimeters, after about 2 minutes, the steam will come out

from the frothing device. Froth milk in the way moving vessel

round from up to down.

Note: Please don't fill too much water (should be≤150ml),

otherwise the steam amount will be little, and the water

content in frothing milk will be too much.

5. When the required purpose is reached, you can turn the

steam control knob to

the jug and turn the steam control knob to

the residual steam in the tank.

Note:

• Clean steam outlet with wet sponge immediately after

position, the indicator will

position stop frothing. Then remove

position release